All categories

3 years ago

I am worried about your proposal to install a groundwater heating system in my daughter’s school.

2 answers:

7 0

Answer: The temperature would increase assuming it is 30 degree water causing a change in the temperature and assuming it is a seismic groundwater source you are using the earths core to heat the school so it would likely be a stable energy source. There are very few places on the planet where that warm of water is accessible without drilling really deep into the core but if it is there and is a stable fault then the energy would be consistent and stable.

VikaD [51]3 years ago

5 0

Answer: if the temp of the ground water from a seismic vent is actually 30 celcius then it would totally have enough energy to heat to room temperature which is close to half that temperature

you could simply pump the water through a forced air system and the air would absorb heat energy from the water that is circulated through and the air would leave warmer than when it came in. it doesn't need to be increased by 30 degrees celcius, that is likely the sticking point for him

Explanation:

You might be interested in

Is distilled water ionically bonded

evablogger [386]

Yes it is.. because

8 0

3 years ago

Read 2 more answers

What happens to light when it enters a lens?

Angelina_Jolie [31]

It is refracted upon entering a lens

7 0

3 years ago

A 1.85 kg textbook is sitting on a bookshelf 2.23 m above the floor. How much potential energy does it have?

neonofarm [45]

Answer:

$\boxed {\boxed {\sf 40.4299 \ Joules}}$

Explanation:

Potential energy is energy due to position. It is the product of mass, height, and acceleration due to gravity.

$PE= m \times g \times h$

The mass of the textbook is 1.85 kilograms. Assuming this is on Earth, the acceleration due to gravity is 9.8 meters per square second. The height is 2.23 meters.

m= 1.85 kg
g= 9.8 m/s²
h= 2.23 m

Substitute the values into the formula.

$PE = 1.85 \ kg \times 9.8 \ m/s^2 \times 2.23 \ m$

Multiply the first 2 numbers together.

$PE=18.13 \ kg*m/s^2 *2.23 \ m$

Multiply again.

$PE= 40.4299 \ kg*m^2/s^2$

1 kilogram square meter per square second (1 kg*m²/s²) is equal to 1 Joules (J)
Our answer of 40.4299 kg*m²/s² is equal to 40.4299 J

$PE= 40.4299 \ J$

The textbook has <u>40.4299 Joules of potential energy.</u>

7 0

3 years ago

Explain why Ra is larger than Be. With 2 points.

igor_vitrenko [27]

Explanation:

<h2>Radium(Ra)=> </h2>

atomic number=88

<h2>BERYLLIUM (Be)=></h2>

atomic number =4

why is Ra larger than Be

<h3>1. since the atomic number of Ra is greater than Be, the number of electrons is more, which means there are more number of shells present in Ra than Be. </h3><h2>(atomic Radius)</h2>

<h2>2. the more the valence electron (excluding fully filled ones) the less is the nuclear attraction force</h2><h3>since Ra has more valence electron in its outermost shell, the nuclear attraction force is less which means that Ra 's size is greater than Be.</h3>

hope it helps:)

6 0

3 years ago

What is one advantage of using a computer over a graphing calculator

CaHeK987 [17]

PCs are usually more powerful devices w/ higher resolutions than the common graphing calculator.

3 0

4 years ago

Read 2 more answers