We know that the Delta E + W(Work done by non-conservative
forces) = 0 (change of energy)
In here, the non-conservative force is the friction force
where f = uN (u =kinetic friction coefficient)
W= f x d = uNd ; N=mg
Delta E = 1/2 mV^2 -1/2mVi^2
umgd + 1/2mV^2 - 1/2mVi^2 = 0 (cancel out the m term)
This will then give us:
1/2Vi^2-ugd = 1/2V^2
V^2 = Vi^2 - 2ugd
So plugging in our values, will give us:
V= Sqrt (5.6^2 -2.3^2)
=sqrt (26.07)
= 5.11 m/s
- The potential difference between two locations in an electric circuit is measured using a voltmeter.
- If the electricity passes through the voltmeter it shows deflection.
<h3>What is the purpose of a voltmeter?</h3>
- A voltage meter, usually referred to as a voltmeter, is a device that measures the voltage, or potential difference, between two points in an electrical or electronic circuit.
- volts is the unit of voltmeter(volts, millivolts, kilovolts)
<h3>What is the explanation for the link between current and voltage?</h3>
- Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it, provided all physical conditions and temperatures remain constant.
<h3>What is ohm's law in circuit?</h3>
- V = IR, where V is voltage, I is current, and R is resistance, is known as Ohm's Law.
- If you know the voltage of the battery in the circuit and how much resistance is in the circuit, you may use Ohm's Law to identify properties of a circuit, such as how much current is flowing through it.
To learn more about current and voltage visit:
brainly.com/question/10254698
#SPJ4
This can be solve using the formula P = I^2 * Rwhere P is the powerI is the CurrentR is the resistanceP = I^2 * R
1/4 Watt = I^2 * 100 ohm solve for II^2 = 1/400 I = 0.05 amps then using the formula to solve for the voltage:V = I * RV = 0.05 amps * 100 ohms V = 5 volts
The wavelengths of radio waves are much "Longer" than the wavelength of microwaves therefore, radio waves carry much "Lower" <span>energy than a microwave.
Hope this helps!</span>
Answer:
Buffers
Explanation:
A buffer solution is a solution containing weak acids and their salts or weak bases and their salts.
A buffer solution is an equilibrium system that resists changes in pH or pOH when a small amount of an acid or base is added hence it is a solution of fairly constant pH value.