Assuming decoders with enabler.
input with rectangle is the ENABLE input.
wire with "/" on it is a bundled wire with multiple values to save drawing space.
In1 is MSB, In5 is LSB.
messy drawing as I'm in vehicle.
Answer:
the first equation is 140.2
what's the last eqaution U???
Explanation:
Answer:
You should now be able to give IP addresses to 254 hosts. This works fine if all 150 computers are on a single network. However, your 150 computers are on three separate physical networks. Instead of requesting more address blocks for each network, you divide your network into subnets that enable you to use one block of addresses on multiple physical networks
Explanation:
Answer:
Solution part of the question:
if(userTickets>5) //compare the value of userTickets with 5.
awardPoints = 10; // assign the 10 value to the award point
else
awardPoints=userTickets;// assign the userticket value to the awardpoint.
Output:
For the input 4 the output is 4.
For the input 5 the output is 5.
For the input 6 the output is 10.
For the input 7 the output is 10.
Explanation:
All the other part of the program is given on the question so here only if-else statement is given on the answer part. Which is pasted at the place of "/* Your solution goes here */" and the user can get the right answer.
- In the "if" statement the value of "userTickets" variable is get compared by 5 and if it is greater than 5 than variable "awardpoint" assigns the '10' value.
- Otherwise, with the help of "else" statement "userticket" variables value (which is the input value for the program) assign to the "awardpoint" variable.
Answer:
Models and Simulations are completely different in that they achieve diffenet results.
Explanation:
Modeling is the act of building a model. A simulation is the process of using a model to study the behavior and performance of an actual or theoretical system. In a simulation, models can be used to study existing or proposed characteristics of a system. ... Simulating is the act of using a model for a simulation.
