Answer:
perimeter = 6w
area = 2w^2
Step-by-step explanation:
we can use the variable w for width, and 2w for length perimeter would be width + width + length + length, or 6w
area is width x length or 2w^2
Answer: second option.
Step-by-step explanation:
You must apply 
Then, given the right triangle and the angle D, the opposite side and the hypotenuse of the triangle are the following:

Therefore, when you substitute values, you have:

Reduce the fraction, then you obtain:

Answer:
-1 to the nearest whole number.
Step-by-step explanation:
(-0.3) ÷ (-0.2)+(-2.56)
Order of operations - the division is done first:
= 1.5 = (-2.56)
= 1.5 - 2.56
= -1.06.
Bolts are usually classified in terms of two types of measurements: the metric system and the imperial system. In calipers, the metric system is in units of millimeters, while the imperial system is in units of inches. For example, when a bolt is sized as 12 × 1.25 in the metric system, that means the bolt thread diameter measures 12 mm, and the thread pitch measures 1.25 mm.
So, if your metric bolt measures 0.78 over the threads, that means that the
size of the bolt is 0.78 mm in thread pitch. The attached picture shows how you measure the thread pitch.
Answer:
Step-by-step explanation:
Given the points (3, 9) and (9, 1), we must first solve for the slope of the line before proceeding with writing the point-slope form.
In order to solve for the slope (<em>m </em>), use the following formula:
m = (y₂ - y₁)/(x₂ - x₁)
Let (x₁, y₁) = (3, 9)
(x₂, y₂) = (9, 1)
Substitute these values into the given formula:
m = (y₂ - y₁)/(x₂ - x₁)
m = (1 - 9)/(9 - 3)

Therefore, the slope of the line, m = -4/3.
Next, using the slope, m = -4/3, and one of the given points, (x₁, y₁) = (3, 9), substitute these values into the following point-slope form:
y - y₁ = m(x - x₁)
⇒ This is the <u>point-slope form</u>.