Answer:
The answer is below
Explanation:
The separation technique is used for separating immiscible liquids.
When separating, the stopper has to be removed when draining the lower layer so as to prevent a vacuum. If vacuum is allowed, the draining rate will reduce and stop.
The liquid should be mixed by shaking the funnel and then opening the stopcock so as the vent out gases.
When near interface between the layers, you should set your eye level so that you do not drain up to the second layer.
After completely draining the first layer, the second layer should be collected in a new flask.
After mixing the solutions in a separatory funnel, the stopper should be removed and the liquid should be mixed thoroughly and the layers allowed to separate. When you get close to the interface between the layers, get eye level with the funnel and slow the draining until the first layer is collected. Switch to a new flask to collect the second layer.
Whenever any substance goes under chemical change so any of the reaction will happen either both or multiple compounds will combine to produce combination reaction either one compound will decompose itself into 2 or more compounds or elements and last one is replacement reaction the either reaction is not even going to combination nor decomposition, So when a reaction like that happens it must replacement reaction.
Now the question is what's the condition required for it, so basically a chemical reaction when takes place it depends upon several factor on the basis of which we conclude products. The factors are Temperature,catalyst,reagents, either what is the mechanism of reaction, stability of reactants and stability of products and alot more.
During reaction sometimes gas forms and sometimes not yea and well that also depends on the chemical reactivity and stability of product sometimes product found itself most stable releasing the gas evolving so it's been done itself and sometimes we add catalyst and adjust the reaction to extract that gas and get desirable product manually.
I wrote all i know if sorry if this is not what you're looking for :(
It is stored in the bonds between atoms.
Nonmetal your welcome
<span />
