Answer:
D.Custom
Explanation:
When you select Custom installation, all Compulsory subcomponents and products are installed, but the Optional and Recommended sub-components and components can be installed selectively on a product-by-product basis for the licenses selected at install time. It also provides the feature to store it in your desirable disk in the hard drive.
Red underline. Hope this helps.
Answer:
Option (D) i.e., Parallel start up is correct option to the following question.
Explanation:
Parallel startup is also an application or software or a way of using the application of the other Operating System in others just like that the following XYZ inc. has trust on older platform but their system give them cautions for update then they use parallel set up by which they also use old software, as well as they, use the Mac's software in Windows. This strategy provides both the option of usage.
Answer:
The solution code is written in Python 3:
- def modifyList(listNumber):
- posCount = 0
- negCount = 0
-
- for x in listNumber:
- if x > 0:
- posCount += 1
- else:
- negCount += 1
-
- if(posCount == len(listNumber)):
- listNumber.append(max(listNumber))
-
- if(negCount == len(listNumber)):
- listNumber.append(min(listNumber))
-
- print(listNumber)
-
- modifyList([-1,-99,-81])
- modifyList([1,99,8])
- modifyList([-1,99,-81])
Explanation:
The key step to solve this problem is to define two variables, posCount and negCount, to track the number of positive value and negative value from the input list (Line 2 - 3).
To track the posCount and negCount, we can traverse through the for-loop and create if else statement to check if the current number x is bigger than 0 then increment posCount by 1 otherwise increment negCount (Line 5- 9).
If all number in the list are positive, the posCount should be equal to the length of the input list and the same rule is applied to negCount. If one of them happens, the listNumber will append either the maximum number (Line 11 -12) or append the minimum number (Line 14-15).
If both posCount and negCount are not equal to the list length, the block of code Line 11 -15 will be skipped.
At last we can print the listNumber (Line 17).
If we test our function using the three sets of input list, we shall get the following results:
[-1, -99, -81, -99]
[1, 99, 8, 99]
[-1, 99, -81]
