All categories

2 years ago

why are you directed not to touch the holder or discharge tube whule the power to the supply to the gas tube is on?

1 answer:

5 0

Every profession has its rules and regulations. The reason why we are directed not to touch the holder or discharge tube while the power to the supply to the gas tube is on because;

The discharge tube can create about 5000 V of voltage when connected to power.

The gas discharge tubes is often very hot when used with the power supplies and one should not to touch them until they are cooled down.

We have been taught to stay far was from a high voltage area or system and also we should not dare to touch it.

There are different reasons why we should about these high voltage system or are; The reason is that;

Because high voltages often reduce the impedance of our skin, thereby making electricity to flow through our bodies.

Learn more about Voltage from

brainly.com/question/1176850

You might be interested in

Difference between velocity profile and velocity distribution

Irina18 [472]

Answer:

Profile is a graphical representation of velocity distribution

7 0

3 years ago

Help asap 9) A poorly tied down blimp falls over in a field. If the blimp exerts a downward force of 4000 N over an area

kari74 [83]

Answer:

$Pressure = 16\ pa$

Explanation:

Given

$Force = 4000N$

$Area = 250m^2$

Required

Determine the pressure

Pressure is calculated using:

$Pressure = \frac{Force}{Area}$

Substitute values for Force and Area

$Pressure = \frac{4000N}{250m^2}$

$Pressure = 16N/m^2$

Change units

$Pressure = 16\ pa$

6 0

3 years ago

A single Gates Rubber V belt is to be selected to deliver engine power to the wheel-drive transmission of a riding tractor. A 5-

beks73 [17]

Answer:

Hello there, please check step by step explanations to get answers.

Explanation:

Given that:

5-hp single-cylinder engine is used. At most, the belt transmits 60 percent of this power. The driving sheave has a diameter of 6.2 in. and the driven, 12.0 in. The belt selected should be as close to 92 in pitch length as possible. The engine speed is governor-controlled to a maximum of 3100 rev/min. Select a satisfactory belt, and specify it using the standard designation.

See attached documents for clearity and step by step procedure to answer

7 0

4 years ago

A car generator turns at 400 rpm (revolutions per minute) when the engine is idling. It has a rectangular coil with 300 turns of

larisa86 [58]

Answer:

The field strength needed is 0.625 T

Explanation:

Given;

angular frequency, ω = 400 rpm = (2π /60) x (400) = 41.893 rad/s

area of the rectangular coil, A = L x B = 0.0611 x 0.05 = 0.003055 m²

number of tuns of the coil, N = 300 turns

peak emf = 24 V

The peak emf is given by;

emf₀ = NABω

B = (emf₀ ) / (NA ω)

B = (24) / (300 x 0.003055 x 41.893)

B = 0.625 T

Therefore, the field strength needed is 0.625 T

4 0

3 years ago

What was the most impressive part of the team's effort?

Phantasy [73]

Answer:

Being a good friend and actually helping others and participate in every way possible

Explanation:

7 0

3 years ago

Read 2 more answers