Answer:
Sprockets.
Explanation:
A chain drive is an efficient technique used for the transmission of mechanical power from one point to another. For example, it is used for transmitting power to the wheels of a bicycle, motorcycle, motor vehicle and other machineries such as chain saw etc.
Chain drive ratio is the ratio between the rotational speeds of the input and output sprockets of a roller chain drive system. This ultimately implies that, chain drive ratio is the ratio of the number of teeth on the driving sprocket (T1) divided to the number of teeth on the driven sprocket (T2).
Also, the chain drive ratio can be calculated by dividing the number of teeth on the large sprocket by the number of teeth on the small sprocket.
Additionally, the rotational speed of a sprocket is measured in revolutions per minute (RPM).
One of the issues with the roller chain is that, as the roller chain moves round the sprocket link by link, it affects its speed (surge) due to the change in acceleration and deceleration i.e the rise and fall of its pitch line.
Answer:
At the point when the quantity of bit strings is not exactly the quantity of processors, at that point a portion of the processors would stay inert since the scheduler maps just part strings to processors and not client level strings to processors. At the point when the quantity of part strings is actually equivalent to the quantity of processors, at that point it is conceivable that the entirety of the processors may be used all the while. Be that as it may, when a part string obstructs inside the portion (because of a page flaw or while summoning framework calls), the comparing processor would stay inert. When there are more portion strings than processors, a blocked piece string could be swapped out for another bit string that is prepared to execute, in this way expanding the use of the multiprocessor system.When the quantity of part strings is not exactly the quantity of processors, at that point a portion of the processors would stay inert since the scheduler maps just bit strings to processors and not client level strings to processors. At the point when the quantity of bit strings is actually equivalent to the quantity of processors, at that point it is conceivable that the entirety of the processors may be used at the same time. Be that as it may, when a part string hinders inside the piece (because of a page flaw or while summoning framework calls), the relating processor would stay inert. When there are more portion strings than processors, a blocked piece string could be swapped out for another bit string that is prepared to execute, along these lines expanding the usage of the multiprocessor framework.
Answer:
Option D
A mineral’s color reflects the wavelengths of light that are absorbed by the mineral.
Explanation:
Color is one of the physical properties of minerals. Many minerals have a wide range of colors but there are some minerals with one consistent color and such minerals are referred as monochromatic minerals for example azurite. Normally, the streak color tends to be less variable than the color of the whole mineral and impurities or minor chemical components in a mineral react and often control the display color of resultant mineral. Option D is incorrect since mineral's color don't reflect wavelengths of light absorbed by such minerals.
Answer:
PERT Chart and GANTT Chart
As the project manager of a residential construction project, I will prefer the PERT chart to the GANTT chart because a PERT chart displays task dependencies unlike a Gantt chart. With the PERT chart, the sequence of tasks is clearly mapped out. Dependent tasks are carried out when other tasks that they depend on have been executed.
Explanation:
By definition, a Gantt chart is like a bar chart that lays out project tasks and timelines using bars. On the other hand, a PERT chart follows a structure in the form of flow charts or network diagrams. It displays all the project tasks in separate boxes. The boxes are then connected with arrows which clearly show the task dependencies.
