Answer:
Explanation:
From the given information;
We will like you to understand that the source port numbers and destination port number can be any number. For that reason, the ones being used here will just be examples.
NOTE:
That the destination port numbers sent from A to S and B to S are the same in their segments.
That the destination port numbers sent from S to A and S to B are the same in their segments.
From A to S, the segment sent possibly could have the source port number 467 and destination port number as 23(Telnet)
From B to S, the segment sent possibly could have the source port number 513 and destination port number as 23(Telnet).
From S to A, the segment sent possibly could have the source port number as 23(Telnet) and destination port number as 467.
From S to B, the segment sent possibly could have the source port number as 23(Telnet) and destination port number as 513.
Yes, it is possible. This is because the inclusion of IP in the segments is to recognize the host.
No, the source ports will be different. Because source port number from A to S can't be the same from B to S at the time they are in the same host.
Answer:
d.
24 to 32
Explanation:
Satellite programmers broadcast, signals to the satellite which they own or lease the channel space from. Uplinked signals sent by the programmers are received by the transponder located on satellite. It is a device which receives signals and transmits them back to Earth after converting the signals to frequency which could be received by the ground-based antenna. <u>There are typically 24 to 32 transponders on a satellite. </u>
Answer:
The switch sends broadcast traffic to all ports like a hub to get the number of ports used and build its MAC address table.
Explanation:
A network switch is a device used in a LAN to connect all available workstations. Unlike a network hub, it is able to send frames from a host or workstation to another using its MAC address table.
An example of a switch is the Cisco 2950 switch. When it is first turned on, it acts as a hub, broadcasting traffic to all its ports. This process is used to create a MAC address table to get the IP address of workstations and the ports they relate to, enabling it to send unicast traffic to a specific port.
Answer:
Print.. is your answer...
