All categories

2 years ago

Lab: Newton's Laws of Motion

Physics

1 answer:

shutvik [7]2 years ago

5 0

Answer:

There are three laws of motion first is also known as law of inertia while second deal with the force and it formula while the third one deals with action and reaction forces

PLEASE MARK ME BRAINLIEST IF MY ANSWER IS CORRECT PLEASE

You might be interested in

With the switch open, roughly what must be the resistance of the resistor on the right for the current out of the battery to be

jeyben [28]

Question:

Assumptions

Voltage of battery = 24 V

Resistance on the right,20Ω parallel to 10 Ω resistor

Answer:

For the current out of the battery to be the same as when the switch was opened with the switch closed, the resistance on the resistor on the right must be approximately 20/3 Ω

Explanation:

We note that the switch in the assumption is on the same line as the 20 Ω resistor.

With a voltage of 24 V, and the switch closed, we have;

Total resistance = $\frac{1}{\frac{1}{10} +\frac{1}{20} } = \frac{20}{3} \Omega$

Current out of voltage, I = Voltage/(total resistance)

= 24 ÷ 20/3 = 24 × 3/20 = 18/5 A

Therefore, with the switch opened, we get

Resistance on the right = Initial total resistance $= \frac{20}{3} \Omega$

Therefore, with the switch opened, the resistance on the resistor on the right must be approximately equal to the resultant resistance of the two resistances in parallel.

6 0

3 years ago

If a point has 40 J of energy and the electric potential is 8 V, what must be the charge?

Alekssandra [29.7K]

If a point has 40 J of energy and the electric potential is 8 V, the charge must be: A. 5 C

<u>Given the following the details;</u>

Energy = 40 Joules

Electric potential = 8 Volts

To find the quantity of charge;

Mathematically, the quantity of charge with respect to electric potential is given by the formula;

$Quantity \; of \; charge = \frac{Energy}{Electric \; potential}$

Substituting the values into the formula, we have;

$Quantity \; of \; charge = \frac{40}{8}$

<em>Quantity of charge = 5 Coulombs</em>

Therefore, the quantity of charge must be <em>5 Coulombs.</em>

Find more information: brainly.com/question/21808222

8 0

3 years ago

Read 2 more answers

A diver leaves the end of a 4.0 m high diving board and strikes the water 1.3s later, 3.0m beyond the end of the board. Consider

shutvik [7]

Answer:

4.0 m/s

Explanation:

The motion of the diver is the motion of a projectile: so we need to find the horizontal and the vertical component of the initial velocity.

Let's consider the horizontal motion first. This motion occurs with constant speed, so the distance covered in a time t is

$d=v_x t$

where here we have

d = 3.0 m is the horizontal distance covered

vx is the horizontal velocity

t = 1.3 s is the duration of the fall

Solving for vx,

$v_x = \frac{d}{t}=\frac{3.0 m}{1.3 s}=2.3 m/s$

Now let's consider the vertical motion: this is an accelerated motion with constant acceleration g=9.8 m/s^2 towards the ground. The vertical position at time t is given by

$y(t) = h + v_y t - \frac{1}{2}gt^2$

where

h = 4.0 m is the initial height

vy is the initial vertical velocity

We know that at t = 1.3 s, the vertical position is zero: y = 0. Substituting these numbers, we can find vy

$0=h+v_y t - \frac{1}{2}gt^2\\v_y = \frac{0.5gt^2-h}{t}=\frac{0.5(9.8 m/s^2)(1.3 s)^2-4.0 m}{1.3 s}=3.3 m/s$

So now we can find the magnitude of the initial velocity:

$v=\sqrt{v_x^2+v_y^2}=\sqrt{(2.3 m/s)^2+(3.3 m/s)^2}=4.0 m/s$

4 0

4 years ago

When you start the simulation, there is no friction and no air resistance ("Air Drag"). Apply full force to the right, 200N. Wil

kakasveta [241]

Answer:Like friction, the drag force always opposes the motion of an object. ... The drag coefficient can depend upon velocity, but we will assume that it is a ... At highway speeds, over 50% of the power of a car is used to overcome air drag. ... A zero net force means that there is no acceleration, as given by Newton's second law.

3 0

3 years ago

He measures 100ml of hot water (90 degrees) using a graduated cylinder he places this sample in the refrigerator to cool it down

Rasek [7]

The volume of the water, which was initially 100mL changed to 96mL after refrigeration because the volume of water reduces when cool.

<h3>Why does water change in volume?</h3>

Water is a substance that is known for its unique characteristics that makes it stand out among all other liquids.

One notable feature of water is it's ability to become denser when subjected to cooler temperatures i.e. water is more dense when cold.

As water cools or becomes less warm, it contracts and decreases in volume. When water decreases in volume, it becomes more dense.

Therefore, according to this question, it can be said that the volume of the water, which was initially 100mL changed to 96mL after refrigeration because the volume of water reduces when cool.

Learn more about water volume at:brainly.com/question/17322215

#SPJ1

4 0

2 years ago