Answer:
Step-by-step explanation:
63 divided by 9 times 10 minus 2
Answer:
the third option cannot be a function
Step-by-step explanation:
whenever a set or ordered pairs contains an x-value that appears more than once then it cannot form a function
Answer:
see below
Step-by-step explanation:
A protractor is usually a transparent measuring device laid intended to be laid over an angle to be measured. The centerpoint of the protractor's scale is made to coincide with the angle's vertex, and the baseline of the protractor is aligned with one of the angle's rays. The appropriate scale is used to read the angle where the other ray crosses the scale. You usually have to visually determine if the angle is acute or obtuse, so you can choose the correct scale to read.
__
If you're drawing an angle, first draw one ray and locate the vertex on it. Then do the steps above as you would for measurement. Make a mark on your paper corresponding to the desired angle measure, and connect the vertex to that mark to create the other ray of the angle.
__
If you're working with a printed protractor, you may need to do your work on a piece of translucent paper or transparency material, so you can see the protractor scale through the page you're drawing on.
_____
<em>Comment on a printed protractor</em>
A protractor will only give accurate measurements if its geometry is perfect. Some printers will scale a figure differently in horizontal and vertical directions, so will make the protractor scale be elliptical instead of circular. That will give wrong readings.
The area of the parallelogram is 40 centimeters
Part A.
The trip starts at 8am which corresponds to 0 hrs, point (0hr, 0mi)
2hrs later it's 10am. .point (2hr, 140mi)
The average speed is the slope between 0 and 2 hrs. Remember the slope formula m = Δy/Δx
m = (140 - 0) / (2 - 0)
m = 70 mph
Part B. Average speed from 11am - 2pm
11am is point (3hr, 140mi)
2pm is point (6hr, 300mi)
As you can see from the graph, the speed or slope changes at 1pm (5,260). You Can just use the start and end points.
m = (300-140) / (6-3)
m = 160/3
53.3 mph
* It comes out the same solution as if you average the two different slopes. 2hrs at 60mph + 1 hr at 40mph = (120 + 40)/3 = 160/3
Part C. Total average speed = total distance / total time driving
He went 70 mph for 2 hrs
stopped for an hour (slope is zero, no speed)
60 mph for 2hrs
40mph for 1 hr
300mi /5hr = 60mph
Part D. No Question....