Answer:
When an instruction is sent to the CPU in a binary pattern, how does the CPU know what instruction the pattern means
Explanation:
When the CPU executes the instructions, it interprets the opcode part of the instruction into individual microprograms, containing their microcode equivalents. Just so you know, a full assembly instruction consists of an opcode and any applicable data that goes with it, if required (register names, memory addresses).
The assembly instructions are assembled (turned into their binary equivalent 0s and 1s, or from now on, logic signals). These logic signals are in-turn interpreted by the CPU, and turned into more low-level logic signals which direct the flow of the CPU to execute the particular instruction.
Answer:
A. 0
Explanation:
The technician should configure the RAID 0 for Joe.
RAID 0 also referred to as the striped volume or stripe set is configured to allow the fastest speed and the most storage capacity by splitting data evenly across multiple (at least two) disks, without redundancy and parity information.
Also, RAID 0 isn't fault tolerant, as failure of one drive will cause the entire array to fail thereby causing total data loss.
Answer:
The answer is "Option a"
Explanation:
This payment is equivalent to the regular rent formally specified by the same contract that grants the member the rights for a specified time. It used both the nominal lending rate and the lessor's conditional value, which provides the lower implied rate, and wrong choices can be described as follows:
- In option b, It is wrong because in this we assume the implicit rate is lessee.
- Option c and Option d both were wrong because It doesn't use the Iterative credit rate.
A sample HTML code that contains headers, paragraph tags, hyperlinks is
- <h1> This is a header </h1>
- <h2> This is a subtitle heading </h2>
- <p> This is a paragraph </p>
- <a href=”www.brainly.com”> Brainly Website </a>
<h3>What is HTML?</h3>
This is the building block of a website and is an acronym that means Hypertext Markup Language.
The HTML code that can be used to add a sample image is: "<img src="pic_Brainly.jpeg" alt="Brainly" width="500" height="333">
The src code means the specific location of the external resource
The width and height show how tall and wide the image would be.
The alt shows the alternative information for the image that can be seen when a person hovers over the image on the website.
Read more about HTML and CSS here:
brainly.com/question/24051672
#SPJ1
