ASAP!!!!! What happen before mitosis occurs ?

We may notice that change in velocity can be obtained by calculating areas between acceleration lines and horizontal axis ("Time"). Mathematically, we know that:

$v_{b}-v_{a} = \int\limits^{t_{b}}_{t_{a}} {a(t)} \, dt$

$v_{b} = v_{a}+ \int\limits^{t_{b}}_{t_{a}} {a(t)} \, dt$

Where:

$v_{a}$ , $v_{b}$ - Initial and final velocities, measured in meters per second.

$t_{a}$ , $t_{b}$ - Initial and final times, measured in seconds.

$a(t)$ - Acceleration, measured in meters per square second.

Acceleration is the slope of velocity, as we know that each line is an horizontal one, then, velocity curves are lines with slopes different of zero. There are three region where velocities should be found:

Region I (t = 0 s to t = 4 s)

$v_{4} = 2\,\frac{m}{s} +\int\limits^{4\,s}_{0\,s} {\left(-2\,\frac{m}{s^{2}} \right)} \, dt$

$v_{4} = 2\,\frac{m}{s}+\left(-2\,\frac{m}{s^{2}} \right) \cdot (4\,s-0\,s)$

$v_{4} = -6\,\frac{m}{s}$

Region II (t = 4 s to t = 6 s)

$v_{6} = -6\,\frac{m}{s} +\int\limits^{6\,s}_{4\,s} {\left(1\,\frac{m}{s^{2}} \right)} \, dt$

$v_{6} = -6\,\frac{m}{s}+\left(1\,\frac{m}{s^{2}} \right) \cdot (6\,s-4\,s)$

$v_{6} = -4\,\frac{m}{s}$

Region III (t = 6 s to t = 10 s)

$v_{10} = -4\,\frac{m}{s} +\int\limits^{10\,s}_{6\,s} {\left(2\,\frac{m}{s^{2}} \right)} \, dt$

$v_{10} = -4\,\frac{m}{s}+\left(2\,\frac{m}{s^{2}} \right) \cdot (10\,s-6\,s)$

$v_{10} = 4\,\frac{m}{s}$

Finally, we draw the object's velocity graph as follows. Graphic is attached below.

3 0

4 years ago

Read the following questions and answer them using complete sentences. Be sure to fully explain your answers.

astra-53 [7]

Wave power can be regarded as a reliable source of energy because the ocean currents are always moving.

<h3>What can be the challenges of wave power?</h3>

Wave power is a device that can be used to convert the mechanical energy of the ocean waves into electrical energy based on the principle of conservation of energy.

The major challenges that face the use of wave power in electricity generation is the unreliability of the waves which leads to uncertainty in the quantity of power generated Also, the wave direction and direction of ocean currents all limit the amount of power generated by this method. However, in spite of challenges, it can be regarded as a reliable source of energy because the ocean currents are always moving.

Learn more about wave power:brainly.com/question/1362067

#SPJ1

6 0

2 years ago