Answer:
series
Explanation:
In a series circuit all the components are attached to one branch, so that if one component fails, all the others stop working. In a parallel circuit, however, the components are wired in separate branches, so that even if one branch fails, the rest are not disrupted.
Answer:
A, The same amount of gravity
Explanation:
Answer:
The work done on the Frisbee is 1.36 J.
Explanation:
Given that,
Mass of Frisbee, m = 115 g = 0.115 kg
Initial speed of Frisbee, u = 12 m/s at a point 1 m above the ground
Final speed of Frisbee , v = 10.9674 m/s when it has reached a height of 2.00 m. Let W is the work done on the Frisbee by its weight. According to work energy theorem, the work done is equal to the change in its kinetic energy. So,
So, the work done on the Frisbee is 1.36 J. Hence, this is the required solution.
I think its inductance. If its not then I think its none of the above
You did not provide the options. However, the options are
I = 6.0, R= 4.0 ohms
I = 9.0, R= 2.0ohms
I = 3.0, R= 2.0ohms
I = 8.0, R= 8.0 ohms
Answer:
The order of the resistors from the highest to the lowest is:
I = 8.0, R= 8.0 ohms
I = 6.0, R= 4.0 ohms
I = 9.0, R= 2.0ohms
I = 3.0, R= 2.0 ohms
Explanation:
ohm's law states that voltage across a conductor is directly proportional to the current flowing through it. V = IR
Based on this formula, the voltages in each of the resistors are calculated below from the highest to the lowest
V = 8 * 8 =64 volts
V = 6 * 4 =24 volts
V = 9 * 2 =18 volts
V = 3 * 2 =6 volts
