Answer:
y = 
Step-by-step explanation:
The function will be cubic. The x-intercepts are -4, -1, and 2
The constant factor is -1 because the graph falls on the right. So,
y = -(x + 4)(x + 1)(x - 2)
y = -
Answer:
The decay rate is 5%.
Step-by-step explanation:
Let a substance is decaying at the rate of r% per hour from the initial value of P for t hours, then the final value of the substance is given by the function
........... (1)
Comparing this equation with the original equation given as
............ (2) we get,
⇒
⇒ r = 5%.
Therefore, the decay rate is 5%. (Answer)
Answer:
30 tiles
Step-by-step explanation:
SO we need to find the area of the wall so we do
8 feet * 5 feet = 40 feet squared
then we find that area in inches
40*12=480
Now we find the area of the tiles
4*4=16
So now we divide to find how many tiles are needed
480/16=30
Our answer is 30
Answer:
Table A: f(x) = -4x - (-5)
Table B: f(x) = 4x + ⅖
Table C: f(x) = -4x + (-⅕)
Step-by-step explanation:
See explanation in the attachement below
Answer:
"Make sure one of them is a match"
Step-by-step explanation:
It takes a little practice and above all to generate heat through friction. By raising the temperature of the woods, it is possible to reach the ignition temperature through friction.
Fires require good equipment and good technique. The majority of times it fails is due to a lack of technique and equipment. This can make learning difficult.
For wood selections, you generally want to comply with the following:
- Dry Tinder
- You should be able to press the wood. If you can't, then it is too difficult.
- Wood not very strong but not soft
- Not sap in the wood
Make the friction forming a 90 degree angle between them, like a cross. Keep one of the sticks supported on the floor vertically, and the other horizontally rubbing it against it at rapid speed, at intervals.
Under this wood put dry tinder that is able to ignite quickly once you generate the fire.
And for the Puzzle remember the orden of the words:
<h2>Make sure one of them is a match. </h2>
Use tree wood, rub and heat until ignition is generated.