For the data set 1, 1, 2, 5, 6, 6, 9 the median is 5. For the data set 1, 1, 2, 6, 6, 9 the median is 4.
hope it helps you
Answer:
Molecules are made of atoms.
Explanation:
the stationary phase in TLC is a <u>silica gel coated metal plate or paper</u>.
The<u> individual</u> component of the mixure will travel a greater distance up the plate, resulting in a <u>Rf</u> value for the component.
the <u>p-Xylene spot </u> will travel a greater distance as it is the <u>lighter</u> component
Bromobenzene will travel least as it is the <u>heavier</u> component.
thin layer chromatography (TLC) is a type of chromatographic seperation technique that is based on the molecular size of components. the Rf value is the distance covered by the component relative to that travelled by the solvent which is the mobile phase
Answer:
1. Galvanic oxidation. Example is the corrosion of aluminium wires when in contact with copper wires under wet conditions.
2. Rainwater or Damp/moist air
3. Chromium-plated steel screws or stainless steel screws or galvanized steel screws
Explanation:
1. Galvanic oxidation or corrosion occurs when two different metals with different electrode potentials are brought into contact with each other by means of an electrolyte (usually a aqueous solution), such that a redox reaction occurs leading to one metal with the more negative electrode potential (the anode) becoming oxidized, while the other less negative potential (the cathode) is reduced.
In order for galvanic corrosion to occur, three elements are required.
i. Two metals with different corrosion potentials (anode and cathode)
ii. Direct metal-to-metal electrical contact
iii. A conductive electrolyte solution (e.g. water) must connect the two metals on a regular basis.
For example oxidation (corrosion) of aluminium wires when in contact with copper wire under wet conditions.
2. The most likely electrolyte will be rainwater containing dissoved solutes (if the panel is in an exposed part of the house) or damp/moist air.
3. From the table, the most likely screw will be chromium-plated steel screws or stainless steel (made of iron and nickel) screws or galvanized steel (zinc-plated) screws.
All these possible screw components have a more negative electrode potential than copper. Thus they will serve as the anode in a galvanic oxidation with copper.
