When testing a laptop power connector, the voltage measured has be close to +/- 5% to the accepted voltage of the laptop. This is to ensure that the power connector would not pose any hazard to the user and is safe for use. So, for instance the accepted voltage is 19 V, when you test the power connector it should be that the reading is between 18 V to 20 V. Any reading below or above that range is not recommended for use. You can locate the accepted voltage on the battery or the laptop itself. To test a power connector, you can use a volt meter or a multi meter.
A dielectric fabric is used to split the conductive plates of a capacitor. This insulating cloth significantly determines the properties of a component. The dielectric constant of fabric determines the amount of strength that a capacitor can keep while voltage is applied.
A capacitor is an electrical component that attracts energy from a battery and stores the power. Internal, the terminals connect with metal plates separated by way of a non-engaging in substance. While activated, a capacitor quickly releases electricity in a tiny fraction of a 2d.
Capacitor, a tool for storing electric electricity, together with two conductors in near proximity and insulated from each different. A simple example of this sort of garage tool is the parallel-plate capacitor.
A capacitor is a tool that shops electric power in an electric-powered area. it is a passive digital thing with terminals. The effect of a capacitor is called capacitance.
Learn more about capacitors here brainly.com/question/13578522
#SPJ4
Sadly, no. The statement kind of has some appropriate words in it, but it's badly corrupted. Objects don't fall to Earth at a rate of 9.8 m/s, and the force that accelerates them downward is not a centripetal one.
<u>Answer:</u>
Option: D. Gravity is pulling the crash test dummy in the direction the car is moving.
<u>Explanation:
</u>
When a car accelerates from a standing start, the crash test dummy appears to be pressed backward into the seat cushion because the gravity is pulling the crash test dummy in the direction the car is moving.
Basically when the car is starting, the person inside is in static position and the car is going to move. So it is putting a force on the person to move on the same speed. But as the person is sitting static hence gravity is pulling him behind from moving. Hence, The dummy appears to be pressed backward.
