Answer:
here
Explanation:
0.000141 to kilowatt-hours. hope this helped
I would think the last one about the ozone layer
System A undergoes an increase in entropy while system B undergoes a decrease in entropy.
Entropy is the degree of disorderliness of a system. The entropy of a system depends on the number of particles present in the system as well as the state of matter.
Entropy is increased when solid particles dissolve in water because more particles are produced thereby increasing the level of disorderliness in the system.
On the other hand, when vapor is condensed, the degree of disorderliness decreases as gases are converted to liquids.
Learn more: brainly.com/question/13146879
In terms of a deeper scientific reason, I am not sure, but the basic reason is quite simple. "Mud" tends to look like a mix between a solid, dirt, and a liquid, water or some other liquid. Since it is, in fact, a cross between a solid and a liquid, it has properties of both. It has certain physical and visual properties that only a solid would have, such as texture and opaqueness, but it also has physical properties of a liquid. Since it leans more towards the liquid side than the solid side, we say mud "flows" rather than saying that it "rolls" or "bounces".
<span>There is only one formula to use and we should assume ideal gas. This equation is: PV=nRT. For the following questions manipulate this equation to get the answer.
1. n = PV/RT = (249*1000 Pa)(15.6 L)(1 m^3/1000 L)/(8.314 Pa-m^3/mol-K))(21+273) = 1.59 mol
2. P = nRT/V = (1.59)(8.314)(51+273)/(15.6/1000)(1000) = 274.55 kPa
3. Since the answer in #2 is more than 269 kPa, then the tires will likely burst.
4. Reduce pressure way below the limit 269 kPa.</span>
