Answer:
choice 3
Explanation:
Hydrogen bonding occurs when a H is bonded to a highly electronegative atom like F. Towards the upper right corner, most atoms have high electronegativity and small atomic radii, according to periodic trends.
Please give thanks :)
Answer:
A:The reproductive system produces hormones.
B:The reproductive system transports reproductive cells.
C:The reproductive system produces reproductive cells.
Explanation:
A:The reproductive system produces hormones. : The reproductive organs ovaries in females and testes in males produces hormones. The ovaries produce estrogen and progesterone and testes produce testosterone.
B:The reproductive system transports reproductive cells. : The ovaries in females transfers an egg into the fallopian tube and testes in males secrete sperms at the time of copulation the fertilization of egg and sperm leads to the development of zygote the precursor of new life.
C:The reproductive system produces reproductive cells.: The ovaries undergo oogenesis and in testes spermatogenesis takes place to develop egg and sperms respectively.
Explanation:
Answer:
a Weak Base
Explanation:
I apoligise if im incorrect its been a while since I have taken the class.
Answer:
Adding more of gas C to the system
Explanation:
- <em>Le Châtelier's principle</em><em> states that when there is an dynamic equilibrium, and this equilibrium is disturbed by an external factor, the equilibrium will be shifted in the direction that can cancel the effect of the external factor to reattain the equilibrium.</em>
1) Adding more of gas C to the system:
Adding more C gas will increase the concentration of the products side. So, the reaction will be shifted to the left to attain the equilibrium again.
2) Heating the system:
Heating the system will increase the concentration of the reactants side as the reaction is endothermic. so, the reaction will be shifted to the right to attain the equilibrium again.
3) Increasing the volume:
has no effect since the no. of moles of gases is the same in both reactants and products sides.
4) Removing some of gas C from the system:
Removing some of gas C from the system will decrease the concentration of the products side. So, the reaction will be shifted to the right to attain the equilibrium again.
<em>So, the right choice is: Adding more of gas C to the system.</em>
<em></em>
<span>The student should
follow following steps to make 1 L of </span>2.0 M CaCl₂.<span>
<span>
1. First he should
calculate the number of moles of 2.0 M CaCl</span></span>₂ in 1 L solution.<span>
</span>Molarity of the solution = 2.0 M<span>
Volume of solution which should be prepared = 1 L
Molarity =
number of moles / volume of the solution
Hence, number of moles in 1 L = 2 mol
2. Find
out the mass of dry CaCl</span>₂ in 2 moles.<span>
moles =
mass / molar mass
Moles of CaCl₂ =
2 mol</span><span>
Molar mass of CaCl₂ = </span><span>110.98 g/mol
Hence, mass of CaCl</span>₂ = 2 mol x <span>110.98 g/mol
= 221.96
g
3. Weigh the mass
accurately
4. Then take a cleaned and dry1 L volumetric flask and place a funnel top of it. Then carefully add the salt into the volumetric flask and
finally wash the funnel and watch glass
with de-ionized water. That water also should be added into the volumetric
flask.
5. Then add some
de-ionized water into
the volumetric flask and swirl well until all salt are
dissolved.
<span>6. Then top up to
mark of the volumetric flask carefully.
</span></span>
7. As the final step prepared solution should be labelled.