1225
<u>Explanation:</u>
This segment helps initialize sum as 0. The for loop is used to increment with every execution and it is added to the sum. The loop runs 49 times and every time the count is added to the sum. In short it is the sum of first 49 natural numbers i.e 1+2+3+......+49.
Senors are a type of device that produce a amount of change to the output to a known input stimulus.
Input signals are signals that receive data by the system and outputs the ones who are sent from it. Hope this helps ;)
Have you seen the state of her body. Mad. If I wear it I ain’t wearing a jolly. ADEOLA wanna ride in the gysa
Answer:
Answer explained below
Explanation:
The following is the nested if-else statement:
% if-based statement
if num < -2 || num > 4
f1(num)
else
if num <=2
if num >= 0
f2(num)
else
f3(num)
end
else
f4(num)
end
end
<u>NOTE:</u> the num is an integer variable that has been initialized and that there are functions f1, f2, f3 and f4.
The nested if-else statement can be replaced by switch statement as shown below:
switch num
case(0, 1, 2)
f2(num)
case(-2, -1)
f3(num)
case(3, 4)
f4(num)
otherwise
f1(num)
In this case, the switch based code is easier to write and understand because the cases are single valued or a few discrete values (not ranges of values)
Answer:
125 cm³/min
Explanation:
The material rate of removal is usually given by the formula
Material Rate of Removal = Radial Depth of Cut * Axial Depth of Cut * Feed Rate, where
Radial Depth of Cut = 25 mm
Axial depth of cut = 200 mm
Feed rate = 25 mm/min
On multiplying all together, we will then have
MRR = 25 mm * 200 mm * 25 mm/min
MRR = 125000 mm³/min
Or we convert it to cm³/min and have
MRR = 125000 mm³/min ÷ 1000
MRR = 125 cm³/min
