3 years ago

To avoid whiplash, the center of the headrest must be _____ your ears.

Engineering

2 answers:

Margarita [4]3 years ago

5 0

Answer:

Explanation:

bulgar [2K]3 years ago

4 0

Answer:

A. higher than

Explanation:

You might be interested in

Which conditions are required for nuclear fusion to begin

Thepotemich [5.8K]

Fusion processes require fuel and a confined environment with sufficient temp, pressure, and confinement time to create a plasma in which fusion can occur.

6 0

3 years ago

Only an outer panel is being replaced. Technician A says that removing the spot welds by drilling through both panels allows the

Angelina_Jolie [31]

Answer:

6e66363636633747747363637737373737337374

5 0

3 years ago

In casting experiments performed using a certain alloy and type of sand mold, it took 170 sec for a cube-shaped casting to solid

poizon [28]

Answer:

Answer for the question is : Solidification time will be same i.e. 170. See attached file for explanation.

Explanation:

Download pdf

7 0

3 years ago

Read 2 more answers

Going green means: increasing one's initiatives toward a concern for the environment. increasing one's bottom line, before any o

Tcecarenko [31]

Answer:

Going green means increasing one's initiatives toward a concern for the environment.

Explanation:

Going green involves all the knowledge and practices that can lead to more environmentally friendly and ecologically responsible decisions and lifestyles, which would protect and sustain the natural resources present in the environment for both present and future generations.

8 0

4 years ago

1. Design a circuit, utilizing set/reset coils where PB 1 starts Motor 1 and PB2 stops Motor 1. Pressing and releasing either pu

lianna [129]

Answer:

Circuit attached with explanation

Explanation:

Hi Dear,

A circuit is attached for your reference.

When you press "start" PB, the supply reaches the motor starter relay coil "M" that is also in parallel with the "start" PB which allows the motor to remain ON even when you release "start" PB as supply to relay coil is directly from supply "L" through "M".

To stop motor just press "stop" PB and the circuit breaks which de-energize the relay coil and the motor stops.

Hope this finds easy to you.

5 0

3 years ago