What happens to the ocean water as it moves from Antarctica to the equator is : ( B ) It becomes less dense and rises to the surface.
<h3>Concept conveyor belt </h3>
The conveyor belt is a system of oceans which transports water and propel deep current of water bodies across the globe based on the differences in water densities.
As the ocean water moves from the Antarctica to the equator the cold ocean water mixes with the warm ocean water at the equator, which makes the water less dense and rises to the surface.
Hence we can conclude that What happens to the ocean water as it moves from Antarctica to the equator is It becomes less dense and rises to the surface.
Learn more about the conveyor belt : brainly.com/question/14910379
#SPJ1
Sound quality can be divided into amplitude, timbre and pitch. If there’s an impedance mismatch between your two devices connected to the single output, you could have a large mismatch between the levels arriving at each device. If the difference is large enough, one device may have distorted or inaudible audio.
To avoid this, you should ensure that both devices connected to the split signal are similar - such as 2 pairs of headphones, 2 recorder inputs, and so on. When you place 2 devices with wildly differing load impedances on a splitter is when you’ll encounter problems - such as headphones on one split and a guitar amp input on the other.
To get around this, you can use either a distribution amplifier (D.A.) or a transformer balanced/isolated splitter - which will work over a larger range of load impedances, typically. Depends on the quality of the splitter and the exact signal path. If you’re using the splitter to hook two things into one input, and you’re using quality connectors, you probably won’t lose much quality. There can be an increase in impedance of the cable due to the imperfect continuity of the physical connection, however with unbalanced line-level signals, impedance at both ends of the chain tends to be orders of magnitude higher than the connection will create, so one split will be barely noticeable. So too, the noise increase from the additional length of cable.
Now, one source into two inputs, that will by basic math and physics result in a 3dB drop in signal strength, which will reduce SNR by about that much. By splitting the signal path between two inputs of equal impedance, half of the wattage is being consumed by one input and half by the other (the equation changes if the inputs have significantly different impedances). So each input gets half the wattage produced by the source to drive the signal on the input cable, and in decibel terms a halving of power is a 3dB reduction. Significant, until you just turn the gain back up. The “noise floor” will be raised by however much noise is inherent in the signal path between the split and the output of the gain stage; for pro audio this is usually infinitesimal, but consumer audio can have some really noisy electronics, both for lower cost and because you’re not expected to be “re-amping” signals several times between the source and output.
Bryophytes never form xylem tissue, the special lignin- containing, water-conducting tissue that is found in the sporophytes of all vascular plants.
Answer:
The correct answer is - all of the above.
Explanation:
Rheumatoid arthritis (RA) causes aggravation of the linning of the joints, particularly in the hands, knee, and fingers. Signs and side effects incorporate red, swollen, excruciating joints, and diminished flexibility and mobility. Articular cartilage is damaged and fibrous tissue invades
If left untreated, it can make extreme harm to the joints and serious complexities in the significant organs. In it, fibrous tissues ossify and bones fuse Rheumatoid joint inflammation is an immune system illness and osteoarthritis is brought about by impacts of maturing. The synovial membrane becomes inflamed and thickens, forming a mass.
The correct answer is - all of the above.
The effector in a negative feedback system acts to counter any changes made to a particular property. If it were positive feedback, it would amplify the change and make it more extreme
