Answer:
The solution for this question is attached below:
Answer:
Europe and most other countries in the world use a voltage which is twice that of the US. ... Originally Europe was 120 V too, just like Japan and the US today, but it was deemed necessary to increase voltage to get more power with fewer losses and less voltage drop from the same copper wire diameter
www.worldstandards.eu › electricity › why-no-standard-voltage
Explanation:
Check them to see if the cylinder is running rich or lean. This can be determined by looking at the electrodes on the plugs
Hope this helps.
<u>Cable should be pre-cut and hung suspended for 48 hours to develop its most natural set and lay prior to installation.</u>
<u>Cable should be installed with, not against, its natural set. ... </u>
<u>Strain relief on either end will reduce conductor breakage at the flex points.</u>
Answer:
) You must create a Low Pass Filter for an audio amplifier. You must pass 10khz and block
60khz. In designing this, you must choose a cutoff frequency exactly half way between
these two frequencies. In addition, you must use a 0.2uF capacitor in you LPF circuit.
Given these criteria, analyze this circuit, and determine the necessary resistor value in
Ohms. Find the output Voltage at both ends of the spectrum. Based on your results, is
this a good design? NOTE: You MUST show your work (when using MS Word, choose
“Insert”--- “Equation”). (6 marks)
a. Solve for fc
b. Solve for R
c. Solve for Vout at 10khz
d. Solve for Vout at 60khz
e. Good design> (yes or no with an explanation)
Explanation:
