Answer:
Explanation:
The result will be affected.
The mass of KHP weighed out was used to calculate the moles of KHP weighed out (moles = mass/molar mass).
Not all the sample is actually KHP if the KHP is a little moist, so when mass was used to determine the moles of KHP, a higher number of moles than what is actually present would be obtained (because some of that mass was not KHP but it was assumed to be so. Therefore, there is actually a less present number of moles than the certain number that was thought of.
During the titration, NaOH reacts in a 1:1 ratio with KHP. So it was determined that there was the same number of moles of NaOH was the volume used as there were KHP in the mass that was weighed out. Since there was an overestimation in the moles of KHP, then there also would be an overestimation in the number of moles of NaOH.
Thus, NaOH will appear at a higher concentration than it actually is.
Answer:
Plants will absorb water through their roots and release water as vapor into the air through these stomata. To survive in drought conditions, plants need to decrease transpiration to limit their water loss. Some plants that live in dry conditions have evolved to have smaller leaves and therefore fewer stomata.
Explanation:
Plants will absorb water through their roots and release water as vapor into the air through these stomata. To survive in drought conditions, plants need to decrease transpiration to limit their water loss. Some plants that live in dry conditions have evolved to have smaller leaves and therefore fewer stomata.
Answer:
p3=0.36atm (partial pressure of NOCl)
Explanation:
2 NO(g) + Cl2(g) ⇌ 2 NOCl(g) Kp = 51
lets assume the partial pressure of NO,Cl2 , and NOCl at eequilibrium are P1 , P2,and P3 respectively
p1=0.125atm;
p2=0.165atm;
p3=?
Kp=51;
On solving;
p3=0.36atm (partial pressure of NOCl)
Answer:
The correct answer is m= mol solute kg soivent
Explanation:
Molality is a measure of concentration, which indicates the moles of solute (in this case sodium hydroxide) in 1kg of solvent .
In this case:
0,800 kg water-----0,400 mol NaOH
1 ,000 kg water ---x=(1 ,000 kg water x 0,400 mol NaOH)/0,800 kg water
x=0,5 mol NaOH---> <em>The solution is 0,5 molal (0,5 m)</em>