Answer: 0.95 inches
Explanation:
A direct load on a column is considered or referred to as an axial compressive load. A direct concentric load is considered axial. If the load is off center it is termed eccentric and is no longer axially applied.
The length= 64 inches
Ends are fixed Le= 64/2 = 32 inches
Factor Of Safety (FOS) = 3. 0
E= 10.6× 10^6 ps
σy= 4000ps
The square cross-section= ia^4/12
PE= π^2EI/Le^2
6500= 3.142^2 × 10^6 × a^4/12×32^2
a^4= 0.81 => a=0.81 inches => a=0.95 inches
Given σy= 4000ps
σallowable= σy/3= 40000/3= 13333. 33psi
Load acting= 6500
Area= a^2= 0.95 ×0.95= 0.9025
σactual=6500/0.9025
σ actual < σallowable
The dimension a= 0.95 inches
Answer:
O is truse is the best answer hhahahha
Explanation:
Answer:
98°C
Explanation:
Total surface area of cylindrical fin = πr² + 2πrl , r = 0.015m; l= 0.1m; π =22/7
22/7*(0.015)² + 22/7*0.015*0.1 = 7.07 X 10∧-4 + 47.1 X 10∧-4 = (54.17 X 10∧-4)m²
Temperature change, t = (50 - 25)°C = 25°C = 298K
Hence, Temperature = 150 X (54.17 X 10∧-4) X 298/123 = 242.14/124 = 2.00K =
∴ Temperature change = 2.00K
But temperature, T= (373 - 2)K = 371 K
In °C = (371 - 273)K = 98°C
Answer:
Hello there, please check step by step explanations to get answers.
Explanation:
Given that:
5-hp single-cylinder engine is used. At most, the belt transmits 60 percent of this power. The driving sheave has a diameter of 6.2 in. and the driven, 12.0 in. The belt selected should be as close to 92 in pitch length as possible. The engine speed is governor-controlled to a maximum of 3100 rev/min. Select a satisfactory belt, and specify it using the standard designation.
See attached documents for clearity and step by step procedure to answer