Answer:
they are used for electrical currents so that they can flow along the appropriate wires in the circuit
Explanation:
Answer:
Density of oil will be 897.292 kg
And specific gravity of oil will be 0.897
Explanation:
We have given density of oil is 1.74 slugs/
We have to convert this slugs/ into kg/
We know that 1 slugs = 14.5939 kg
So 1.74 slug = 1.74×14.5939 = 25.3933 kg
And 1 cubic feet = 0.0283 cubic meter
So 
Now we have to calculate specific gravity it is the ratio of density of oil and density of water
We know that density of water = 1000 kg/
So specific gravity of water 
The rovers were designed to trek up to 100 meters (about 110 yards or 328 feet) across the martian surface each martian day, though they have gone much farther. While a complete martian day (called a sol) is about 24 hours and 40 minutes long (or 24 hours 37.5 minutes if you prefer), the Sun can only provide enough power for driving during a four-hour window around high noon. That means the rovers have to be able to move quickly and effectively.
Moving safely from rock to rock or location to location is a major challenge because of the communication time delay between Earth and Mars, which is about 20 minutes on average. Unlike a remote controlled car, the drivers of rovers on Mars cannot instantly see what is happening to a rover at any given moment and they cannot send quick commands to prevent the rover from running into a rock or falling off of a cliff.
During surface operations on Mars, each rover receives a new set of instructions at the beginning of each sol. Sent from the scientists and engineers on Earth, the command sequence tells the rover what targets to go to and what science experiments to perform on Mars. The rover is expected to move over a given distance, precisely position itself with respect to a target, and deploy its instruments to take close-up pictures and analyze the minerals or elements of rocks and soil.
Answer:
Simple G Code Example Mill - This is a very simple G code example for beginner level ... Run the program on your cnc machine (Safety first, keep a professional around). ... This G code program example don't use Tool radius compensation ...
Explanation:
