How long does it take an airplane to fly 5000m if it maintains a speed of 240 meters per second

Three resistors of 100 W, 3900 W, and 1000 W are connected in series across a 200-V battery. What is the voltage drop across the

Gala2k [10]

Answer:

40 V

Explanation:

I will assume that the resistors are

100 and 3900 and 1000 OHMS <=====(NOT W)

In series , the resistances add together 100 + 3900 + 1000 = 5000 ohms total

V = IR

I = V / R so the total current will be 200 v / 5000 ohms = .04 amps

this is the current through all of the resistors

so for the 1000 ohm resistor V = IR .04 (1000) = 40 V

7 0

2 years ago

Water is pumped steadily out of a flooded basement at a speed of 5.4 m/s through a uniform hose of radius 0.83 cm. The hose pass

Gala2k [10]

To solve this problem it is necessary to apply the concepts related to the flow as a function of the volume in a certain time, as well as the potential and kinetic energy that act on the pump and the fluid.

The work done would be defined as

$\Delta W = \Delta PE + \Delta KE$

Where,

PE = Potential Energy

KE = Kinetic Energy

$\Delta W = (\Delta m)gh+\frac{1}{2}(\Delta m)v^2$

Where,

m = Mass

g = Gravitational energy

h = Height

v = Velocity

Considering power as the change of energy as a function of time we will then have to

$P = \frac{\Delta W}{\Delta t}$

$P = \frac{\Delta m}{\Delta t}(gh+\frac{1}{2}v^2)$

The rate of mass flow is,

$\frac{\Delta m}{\Delta t} = \rho_w Av$

Where,

$\rho_w$ = Density of water

A = Area of the hose $\rightarrow A=\pi r^2$

The given radius is 0.83cm or $0.83 * 10^{-2}$ m, so the Area would be

$A = \pi (0.83*10^{-2})^2$

$A = 0.0002164m^2$

We have then that,

$\frac{\Delta m}{\Delta t} = \rho_w Av$

$\frac{\Delta m}{\Delta t} = (1000)(0.0002164)(5.4)$

$\frac{\Delta m}{\Delta t} = 1.16856kg/s$

Final the power of the pump would be,

$P = \frac{\Delta m}{\Delta t}(gh+\frac{1}{2}v^2)$

$P = (1.16856)((9.8)(3.5)+\frac{1}{2}5.4^2)$

$P = 57.1192W$

Therefore the power of the pump is 57.11W

6 0

3 years ago

The diagram below shows the different phase transitions that occur in matter.

Margaret [11]

Answer:A

Explanation:matter normally occurs in three phases;solid, liquid and gases. They may change from one phase to another due to temperature difference.

The molecules that makes up solids are held together by bonds. When heat is added,the molecules begin to move as a result,the bonds break and it turns to liquid.this process is called melting. The reverse of melting is freezing.

Liquid are made up of molecules that moves more freely than solids. When heat is added to liquid,the molecules gain more energy and begins to move faster. This causes them to turn to gases.

This process is called evaporation. It occurs at different temperature for different substances.

The particles of gases move more faster and are separated by large distances. A gas can change back to a liquid through condensation.

7 0

3 years ago

Read 2 more answers

Mike is a runner. Mike runs 200m in 25s; what is his average velocity during the run? assume that units are in m/s. (asap, will

maw [93]

Velocity is displacement/time
(Displacement is the overall change in distance)

So you’ll want to divide 200 by 25, which should give you:

8 m/s

5 0

3 years ago

Against the park ranger's advice, a visitor at a national park throws a stone horizontally off the edge of a 86 m high cliff and

Drupady [299]

The initial horizontal velocity of the rock, in m/s is 21.241 m/s.

<h3>What is projectile?</h3>

When an object is thrown at an angle from the horizontal direction, the object is said to be in projectile motion. The object which follows the projectile motion.

Time taken by the stone to reach the ground is

t = √2h/g

t = √(2x 86)/9.81

t = 4.19s

The horizontal velocity is

V(x) = Horizontal distance traveled / Time taken t

Put the values, we get

V(x) = 89 m/4.19 s

V(x) = 21.241 m/s

Thus, the horizontal velocity is 21.241 m/s

Learn more about projectile.

brainly.com/question/11422992

#SPJ1

4 0

2 years ago