Answer:
Work = 651,1011 kJ
Explanation:
Let´s take the car as a system in order to apply the first law of thermodynamics as follows:
Where
And considering that there is no mass transfer and that the only energy flows that interact with the system are the heat losses and the work needed to move the car we have:
Regarding the energy system we have the following:
By doing the calculations we have:
![E_{system,final}- E_{system,initial}=[0,1*900]_{internal}+[0,5*900(30^2-10^2)/1000)_{kinetic}+(900*10*(20-0)/1000)_{potential}\\E_{system,final}- E_{system,initial}=90+360+180=630kJ](https://tex.z-dn.net/?f=E_%7Bsystem%2Cfinal%7D-%20E_%7Bsystem%2Cinitial%7D%3D%5B0%2C1%2A900%5D_%7Binternal%7D%2B%5B0%2C5%2A900%2830%5E2-10%5E2%29%2F1000%29_%7Bkinetic%7D%2B%28900%2A10%2A%2820-0%29%2F1000%29_%7Bpotential%7D%5C%5CE_%7Bsystem%2Cfinal%7D-%20E_%7Bsystem%2Cinitial%7D%3D90%2B360%2B180%3D630kJ)
Consider that in the previous calculation, the kinetic and potential energy terms were divided by 1.000 to change the units from J to kJ.
Finally, the work needed to move the car under the required conditions is calculated as follows:
Consider that in the previous calculation, the heat loss was changed previously from BTU to kJ.
Given that the correct question is
Write Python expressions using s1, s2, and s3 and operators + and * that evaluate to: (a) 'ant bat cod'
Answer:
s1 = 'ant'
s2 ='bat'
s3 ='cod'
#using string concatenation
s4 = s1 + ' ' + s2 + ' ' +s3
print(s4)
Answer:
See explaination
Explanation:
int RED=10; int BLUE=11; int GREEN=12; int BUTTON1=8; int BUTTON2=9; void setup() { pinMode(RED, OUTPUT); pinMode(BLUE, OUTPUT); pinMode(GREEN, OUTPUT); pinMode(BUTTON1, INPUT); pinMode(BUTTON2, OUTPUT); } void loop() { int BTN1_STATE=digitalRead(BUTTON1); int BTN2_STATE=digitalRead(BUTTON2); if(BTN1_STATE==HIGH) { digitalWrite(BLUE, HIGH); delay(1000); // Wait for 1 second digitalWrite(BLUE, LOW); } if(BTN2_STATE==HIGH) { digitalWrite(RED, HIGH); delay(4000); // Wait for 4 seconds digitalWrite(RED, LOW); } if(BTN1_STATE==HIGH && BTN2_STATE==HIGH) { digitalWrite(GREEN, HIGH); delay(2000); // Wait for 2 second digitalWrite(GREEN, LOW); } }
A specific part of the population is a subgroup.
