The answer is 1040EZ. That is the shortest and simplest tax form.
Answer:
Annotation symbol
Explanation:
A flowchart is a diagram that is used to show and represent a workflow, process or algorithm. Flow charts are used in designing processes or programs. Flow charts are usually designed using boxes and arrows.
An annotation symbol is a symbol used in flowchart to hold comments and it is usually represented by a three-sided box connected to the step it references by a dashed line.
Answer:
Selective Repeat protocols
Explanation:
It is better to make use of the selective repeat protocol here. From what we have here, there is a high error rate on this channel.
If we had implemented Go back N protocol, the whole N packets would be retransmitted. Much bandwidth would be needed here.
But we are told that bandwidth is limited. So if packet get lost when we implement selective protocol, we would only need less bandwidth since we would retransmit only this packet.
<span>Step 1Determine what type of connection you need for your computer and printer. If you see a large rectangular connection on your printer it is a parallel printer, and you will need to make sure you have a parallel port on your computer. This connection will be long and rectangular, and it may be red in color. If your Canon printer has a small square connection on the back it is a USB printer, and you will need to look for a flat slot on your computer to hook it up.Step 2Connect the printer and computer. If you are working with a parallel printer connect the large end of the cable to the back of the printer and the smaller end to the computer. If you have a USB printer, connect the square end of the cable to the back of the printer and the flat end to a free USB port on your computer.Step 3Turn on your printer and the computer. Insert the print cartridges that come with the printer. Watch the lower right-hand corner of your computer screen for a "found new hardware" message. This is your indication that the operating system has found your new printer and is installing the proper driver for it.Step 4Insert the CD that comes with your printer, if you are prompted to do so. If your operating system was unable to find a suitable driver it will prompt you for the CD. Keep your CD handy anyway, because you will need it to install the printer utilities.Step 5Insert the CD and allow it to install your printer utilities. After the utilities are installed you will be prompted to clean and align the print heads on your new printer. After the print heads have been aligned your new Canon printer will be ready for use.hope this helps</span>
I think coders put in codes. Sry if that does not help.
