Answer:
A continuity test
Explanation:
A continuity test is used to verified that current will flow in an electrical circuit, it performed by placing a small voltage across the chosen path. continuity test ensure that the equipment grounding conductor is electrically continuous and this test is perform on all the cord sets, receptacles that aren't part of a building or structure's permanent wiring, and cord-and-plug connected equipment required to be grounded. example of equipment used in testing current flow in continuity test are Analog multi-meter, voltage/continuity tester etc.
Continuity test and terminal connection test are the two test required by OSHA on all electrical equipment
Before installing head gaskets, you should look for "this side up" or "front" labels on the head gaskets.
<h3>What is a
head gasket?</h3>
A head gasket can be defined as a gasket which is fitted between the engine block and the cylinder head in an internal combustion engine, so as to seal oil passages and absorb the pressures of the combustion that occurs inside the engine.
As a general rule, you should look for "this side up" or "front" labels on the head gaskets before installing head gaskets in an internal combustion engine of a vehicle.
Read more on head gaskets here: brainly.com/question/1264437
#SPJ1
In a Class Three Lever, the Force is between the Load and the Fulcrum. If the Force is closer to the Load, it would be easier to lift and a mechanical advantage. Examples are shovels, fishing rods, human arms and legs, tweezers, and ice tongs. A fishing rod is an example of a Class Three Lever.
Answer:
The impedance of the circuit depends on the angular frequency of the voltage source.
Explanation:
- In a electric circuit, the magnitude of the impedance, is given by the following expression:
where R = Resistance
Xl = Inductive reactance = ω*L
Xc = Capacitive Reactance = 1/ωC
and ω = angular frequency of the voltage source.
- So, it can be seen that the impedance depends on the value of the constants R,L and C, and on the angular frequency ω.
Answer:
1. Initial or Pre-training phase.
Explanation:
