Answer:
The definition of the issues is listed throughout the section down.
Explanation:
- Stranded cables are somewhat more compact and can be mounted quickly. Strong cables become rigid in design, and they are not versatile for installation. In comparison with solid connectors, amplification is indeed high.
- Unless the innermost layer including its wire is broken as we attempt to connect the cable, it will not function. So, whenever stripping the cables through the walls, it's indeed important not to rank the jack too profoundly.
- It would be quick to untwist the cable and then will ensure that perhaps the connection is appropriate for the most widely encountered rj-45 connection whenever the wiring of 0.5 inches becomes coupled up.
- If we don't keep the right pin colors in order, the relation won't work. Afterward, when another connexon is broken due to many complications, it would be impossible to figure out the contacts unless the pins coloring are not always in sequence.
- The connection pairs can be cut off through 0.5 inches within about therefore the gap within the connector is narrower and the wire would not be correctly attached if we break the cable further. The link is lost and the cable does not run properly.
- It is necessary to ensure that perhaps the wires are forced to the end of the platform since the connexon will indeed be broken as well as the connector would not operate unless the wires aren't moved. The wires will fall out of another socket as well.
- Before even being incorporated into another crimping unit, it is good to carefully check the connection sequence to ensure that perhaps the wires are to the end since it is impossible to verify the sequence until the wires are attached to something like the connector. Unless the connections are not always in alignment, the link will also not be provided and indeed the wire would not operate correctly, even if the link is provided. Such wires can also be presented to use load barriers, and that it's the simplest operation.
- The Durability Tester has been used to determine the hardness between two stages, whereas the connection efficiency is tested using the qualification tester.
Answer:
Selective Repeat protocols
Explanation:
It is better to make use of the selective repeat protocol here. From what we have here, there is a high error rate on this channel.
If we had implemented Go back N protocol, the whole N packets would be retransmitted. Much bandwidth would be needed here.
But we are told that bandwidth is limited. So if packet get lost when we implement selective protocol, we would only need less bandwidth since we would retransmit only this packet.
Answer:
The explanation of this question is given below in the explanation section. however, the correct option of this question is "Boot the machine into safe mode"
Explanation:
BSOD error on startup
Blue screen of death error arises mostly when dirver produce fault into system or did not install properly. however, the correct option for this question, if PC gets BSOD error on startup then it is the best option for technician to remove the hardware that is recently installed and/or try to boot the machine into safe mode, then uninstall the driver that causing error on startup.
BSOD error occur during running the program on PC
However, if PC get BSOD during running program, then the best option for technician is to restart the machine and then install the driver properly. During this operation, as error occured, you may loss the data becuase you have no other option to save the data of program that is running.
I have to type 20 characters here so...