I'd say MSconfig, you can use that and view the 'processes' tab, but it will make you open up the task manager.
Answer:
Shows the programming checking if num1 is greater than num2
Explanation:
So num1 and num2 are inputs
for you to code this you would need to put
num1=int(input("What is your first number? ))
and the same for num2 except change num1 for num 2 and first for second
When the input is completed, the computer will check if num 1 is greater than num2
it will do this by using a code something like:
if num1>num2:
Print("Your first input was greater than your second")
But in this example if it greater it just ends
But if it was less than you would put
if num1>num2:
Print("Your first input was greater than your second")
elif num1<num2:
Print("Your first input is less than your second")
So basically this code shows the computer checking if one number is greater than the other or not
THE ANSWER IS A!!!!!!!!!!!!!!!!!!!
Answer:
A. 0
Explanation:
The technician should configure the RAID 0 for Joe.
RAID 0 also referred to as the striped volume or stripe set is configured to allow the fastest speed and the most storage capacity by splitting data evenly across multiple (at least two) disks, without redundancy and parity information.
Also, RAID 0 isn't fault tolerant, as failure of one drive will cause the entire array to fail thereby causing total data loss.