the density increases down the group.
Answer:
67.5%
Explanation:
Step 1: Write the balanced equation for the electrolysis of water
2 H₂O ⇒ 2 H₂ + O₂
Step 2: Calculate the theoretical yield of O₂ from 17.0 g of H₂O
According to the balanced equation, the mass ratio of H₂O to O₂ is 36.04:32.00.
17.0 g H₂O × 32.00 g O₂/36.04 g H₂O = 15.1 g O₂
Step 3: Calculate the percent yield of O₂
Given the experimental yield of O₂ is 10.2 g, we can calculate its percent yield using the following expression.
%yield = (exp yield / theoret yield) × 100%
%yield = (10.2 g / 15.1 g) × 100% = 67.5%
Answer: im thinking its gonna be d.C2H6 and also
the explanation is on the research i had did before i had answered this question so i really hope this help :)
Explanation:
Ar = van de waals forces or london forces
C
H
4
= van de waals forces or london forces
HCl=permanent dipole-dipole interactions
CO = permanent dipole-dipole interactions
HF = hydrogen bonding
N
a
N
O
3
= permanent dipole-dipole interactions
C
a
C
l
2
= van de waals forces or london forces
2.0 L
The key to any dilution calculation is the dilution factor
The dilution factor essentially tells you how concentrated the stock solution was compared with the diluted solution.
In your case, the dilution must take you from a concentrated hydrochloric acid solution of 18.5 M to a diluted solution of 1.5 M, so the dilution factor must be equal to
DF=18.5M1.5M=12.333
So, in order to decrease the concentration of the stock solution by a factor of 12.333, you must increase its volume by a factor of 12.333by adding water.
The volume of the stock solution needed for this dilution will be
DF=VdilutedVstock⇒Vstock=VdilutedDF
Plug in your values to find
Vstock=25.0 L12.333=2.0 L−−−−−
The answer is rounded to two sig figs, the number of significant figures you have for the concentration od the diluted solution.
So, to make 25.0 L of 1.5 M hydrochloric acid solution, take 2.0 L of 18.5 M hydrochloric acid solution and dilute it to a final volume of 25.0 L.
IMPORTANT NOTE! Do not forget that you must always add concentrated acid to water and not the other way around!
In this case, you're working with very concentrated hydrochloric acid, so it would be best to keep the stock solution and the water needed for the dilution in an ice bath before the dilution.
Also, it would be best to perform the dilution in several steps using smaller doses of stock solution. Don't forget to stir as you're adding the acid!
So, to dilute your solution, take several steps to add the concentrated acid solution to enough water to ensure that the final is as close to 25.0 L as possible. If you're still a couple of milliliters short of the target volume, finish the dilution by adding water.
Always remember
Water to concentrated acid →.NO!
Concentrated acid to water →.YES!
