Answer: Try mass that’s the best guess I can give off the top of my head
Explanation: An atom is the smallest unit of matter that retains all of the chemical properties of an element. Atoms come together which forms molecules. These molecules interact to form solids, gases, or liquids.
Answer:
5.00 grams of salt contain more particles than 5.0 grams of sugar
Explanation:
Salt = NaCl
Molar mass = 58.45 g/mol
Sugar = C₁₂H₂₂O₁₁
Molar mass = 342.3 g/mol
Sugar's molar mass is higher than salt.
So 1 mol of sugar weighs more than 1 mol of salt
But 5 grams of salt occupies more mole than 5 grams of sugar
5 grams of salt = 5g / 58.45 g/m = 0.085 moles
5 grams of sugar = 5g/ 342.3 g/m = 0.014 moles
In conclusion, we have more moles of salt in 5 grams; therefore there are more particles than in 5 g of sugar.
Answer:
0.0845 M
Explanation:
First we <u>convert 4.27 grams of potassium iodide into moles</u>, using its <em>molar mass</em>:
- Molar Mass of KI = 166 g/mol
- 4.27 g ÷ 166 g/mol = 0.0257 mol
Now we <u>calculate the molarity of the solution</u>, using <em>the number of moles and the given volume</em>:
- Molarity = moles / liters
- Molarity = 0.0257 mol / 0.304 L = 0.0845 M
Polyethene is a polymer composed of repeating units of the monomer ethene.
The properties of polyethene are as follows:
- density- ranges 0.857 g/cm3 to 0.975 g/cm3.
- specific heat capacity is 1.9 kJ/kg.
- melting temperature is approximately 110 °C.
<h3>What are polymers?</h3>
Polymers are large macromolecules consisting of long repeating chains of smaller molecules known as monomers.
An example of a polymer is polyethene composed of repeating units of the monomer ethene.
The density of polyethylene ranges 0.857 g/cm3 to 0.975 g/cm3.
The specific heat capacity of polyethene is 1.9 kJ/kg.
The melting temperature of polyethene is approximately 110 °C.
Learn more about polyethene at: brainly.com/question/165779
Answer:
A. The rate of heat transfer through the material would increase.
Explanation:
To calculate the heat transfer in a heat exchanger you decide that there is not heat leakage to the surroundings, that means that magnitude of the two transfer rates will be equal. Any heat lost by the hot fluid, is gained by the cold fluid. The equation that describes this is Q = m×Cp×dT
Where:
heat = mass flow ×specific heat capacity × temperature difference
So if we increase the rate of flow of cooling water and the other variables that ypu can control remain the same, the result is that the rate of heat transfer through the material would increase, as it is stated in option a.