Answer as an inequality: 
Answer in interval notation: 
Answer in words: Set of positive real numbers
All three represent the same idea, but in different forms.
======================================================
Explanation:
Any log is the inverse of an exponential equation. Consider a general base b such that f(x) = b^x. The inverse of this is 
For the exponential b^x, we cannot have b^x = 0. We can get closer to it, but we can't actually get there. The horizontal asymptote is y = 0.
Because of this,
has a vertical asymptote x = 0 (recall that x and y swap, so the asymptotes swap as well). This means we can get closer and closer to x = 0 from the positive side, but never reach x = 0 itself.
The domain of
is x > 0 which in interval notation would be
. This is the interval from 0 to infinity, excluding both endpoints.
------------------------
The natural log function Ln(x) is a special type of log function where the base is b = e = 2.718 approximately.
So,

allowing all of what was discussed in the previous section to apply to this Ln(x) function as well.
------------------------
In short, the domain is the set of positive real numbers. We can't have x be 0 or negative.
If inspection department wants to estimate the mean amount with 95% confidence level with standard deviation 0.05 then it needed a sample size of 97.
Given 95% confidence level, standard deviation=0.05.
We know that margin of error is the range of values below and above the sample statistic in a confidence interval.
We assume that the values follow normal distribution. Normal distribution is a probability that is symmetric about the mean showing the data near the mean are more frequent in occurence than data far from mean.
We know that margin of error for a confidence interval is given by:
Me=
α=1-0.95=0.05
α/2=0.025
z with α/2=1.96 (using normal distribution table)
Solving for n using formula of margin of error.

n=
=96.4
By rounding off we will get 97.
Hence the sample size required will be 97.
Learn more about standard deviation at brainly.com/question/475676
#SPJ4
The given question is incomplete and the full question is as under:
If the inspection division of a county weights and measures department wants to estimate the mean amount of soft drink fill in 2 liters bottles to within (0.01 liter with 95% confidence and also assumes that standard deviation is 0.05 liter. What is the sample size needed?
Given:
m∠1= x° and m∠2 = (x +50)°.
To find:
The value of x, m∠1 and m∠2.
Solution:
From the figure it is clear that, transversal side intersect the opposite sides which are parallel and form ∠1 and ∠2.
Sum of same sided interior angles is 180 degrees. So,





Divide both sides by 2.


Now,


Therefore, the correct option is C.
Answer:
20% (I believe)
Step-by-step explanation:
If you divide 16 from 320 you should get 20, and 20% of 320 is 16! :3 (I really hope that this helps- I'm not the best at math ;w;)
Yes! It can simplified to 2/5 or in decimal form it would be 0.4 . Hope this helps!