Answer: 1. C. polar covalent: electrons shared between silicon and sulfur but attracted more to the sulfur
2. B) 
3. B) Fluorine
Explanation:
1. A polar covalent bond is defined as the bond which is formed when there is a difference of electronegativities between the atoms.
Electronegativity difference = electronegativity of sulphur- electronegativity of silicon = 2.5 -1.8 = 0.7
Thus as electronegativity difference is less than 1.7 , the cond is polar covalent and as electronegativity of sulphur is more , the electrons will be more towards sulphur.
2. A molecular compound is usually composed of two or more nonmetal elements. Example:
Ionic compound is formed by the transfer of electrons from metals to non metals. Example: 
, 
and 
3. For formation of a neutral ionic compound, the charges on cation and anion must be balanced. The cation is formed by loss of electrons by metals and anions are formed by gain of electrons by non metals.
Here K is having an oxidation state of +1 and as the compound formed is KZ, the oxidation state of non metallic element Z should be -1. Thus the element Z is flourine which exists as diatomic gas 
Given :
Number of molecules of 
.
To Find :
How many moles are in given number of molecules.
Solution :
We know, in 1 moles of any element/compound contains 
at atoms/molecules.
So, number of moles in 
molecules are :
Therefore, number of moles are 8.97 .
Look up a picture of the elements on a periodic table. Start reading from the top.
3.) Charge on one molecule of PO4 is -3. So on two molecule it'll be 2(-3) = -6. Let oxidation number of Pb be x. Therefore, 3x+(-6) = 0. 3x=6. x=2.
The key to most "how do I separate." questions is solubility.
The trick is to add a liquid that will only dissolve one substance but not another.
Let's say you had a beaker full of sand, table salt (NaCl), and acetanilide. Is there anything you can add that would only dissolve one of these three substances?
Yes, there is! Acetanilide like most organic compounds, isn't soluble in water. But salt is soluble in water. So to the mixture, I would add water, and then pass the water through a filter. The filter paper will "catch" the sand and acetanilide, but the table salt will remain dissolved in the water. If you then let that water evaporate (either via boiling or under vacuum), you will recover your salt.
So now, how to do you separate the sand from the acetanilide? Sand isn't really soluble in anything, but acetanilide is soluble in organic solvents, such as ethanol. So to the mixture of sand and acetanilide, add ethanol, and pass it through a filter. The sand will once again get stuck in the filter paper, and your acetanilide will be dissolved in ethanol. Remove the ethanol (via vacuum, or rotovap) and you will be left with acetanilide.
