Answer:
Step-by-step explanation:
Point-slope form.
The steps to use to construct a frequency distribution table using sturge’s approximation is as below.
<h3>How to construct a frequency distribution table?</h3>
The steps to construct a frequency distribution table using Sturge's approximation are as follows;
Step 1: Find the range of the data: This is simply finding the difference between the largest and the smallest values.
Step 2; Take a decision on the approximate number of classes in which the given data are to be grouped. The formula for this is;
K = 1 + 3.322logN
where;
K= Number of classes
logN = Logarithm of the total number of observations.
Step 3; Determine the approximate class interval size: This is obtained by dividing the range of data by the number of classes and is denoted by h class interval size
Step 4; Locate the starting point: The lower class limit should take care of the smallest value in the raw data.
Step 5; Identify the remaining class boundaries: When you have gotten the lowest class boundary, then you can add the class interval size to the lower class boundary to get the upper class boundary.
Step 6; Distribute the data into respective classes:
Read more about frequency distribution table at; brainly.com/question/27820465
#SPJ1
Smaller number, if it's 8 x 1/8 you will get 1.
Its 110 cuz it goes up 10% if it was 20% it would be 120
Summaation of a sequence
or see a smaller scale
from 1 to 10
notice
1+10=11
2+9=11
etc
5+6=11
10/2=5
there are 5 pairs
5*11=55
so
1 to 100
1+100=101
2+99=101
...
50+51=101
100/2=50
there ar 50 pairs
50 times 101=5050
the sum is 5050
