Answer: Solution W and Y solution have more solubility than X and Z
Solutions are homogeneous mixtures of two or more components. By uniform mix we mean that its structure and properties are the same in the whole mix. Generally, the component which is present in the largest quantity is known as solvent. Solvent determines the physical condition in which the solution exists. In addition to the solvent, one or more component present in the solution is called solutes. In this unit we will only consider binary solutions (i.e., with two components)
The structure of the solution can be described by expressing its concentration. The latter can either be expressed qualitatively or quantitatively. For example, in qualitatively we can say that the solution is diluted (i.e., relatively small amounts of solubility) or it is concentrated (i.e., relatively rarely sighs). But in real life such details may be very confusing and thus require a quantitative description of the solution. There are several ways that we can quantitatively describe the concentration of solutions. (i) Mass Percentage (W / W): The mass percentage of a component of the solution is defined as: mass of the component = mass of the component in the solution = 100 Total mass of the solution .For example, if by mass A solution is described by 10% glucose in water, it means that 10 grams of glucose dissolved in 90 grams of water, resulting in 100 grams of solution. The concentration described by a large percentage of the population is usually used in industrial chemical applications. For example, the commercial bleaching solution contains 3.62 mass percentages of sodium hypochlorite in water. (ii) Volume Percentage (V / V): Volume Percentage is defined as: Total Volume of Component Volume 100 (component) Volume% of Component
Explanation:
Answer:
35.14°C
Explanation:
The equation for linear thermal expansion is 
, which means that a bar of length 
with a thermal expansion coefficient 
under a temperature variation 
will experiment a length variation 
.
We have then = 0.481 foot, = 1671 feet and = 0.000013 per centigrade degree (this is just the linear thermal expansion of steel that you must find in a table), which means from the equation for linear thermal expansion that we have a 
= 22.14°. As said before, these degrees are centigrades (Celsius or Kelvin, it does not matter since it is only a variation), and the foot units cancel on the equation, showing no further conversion was needed.
Since our temperature on a cool spring day was 13.0°C, our new temperature must be 
= 35.14°C
Stark contrast to paths on energy surfaces or even mechanistic reactions, rule-based and inductive computational approaches to reaction prediction mostly consider only overall transformations. Overall transformations are general molecular graph rearrangements reflecting only the net change of several successive mechanistic reactions. For example, Figure 1 shows the overall transformation of an alkene interacting with hydrobromic acid to yield the alkyl bromide along with the two elementary reactions which compose the transformation.
Well, the acceleration is the difference of speeds divided by the time period.
.
One rev/s is
, so our final result is
.
