Explanation:
1. A sequence of instructions is stored in memory.
2. The memory address wherever the first instruction is found is copied to the instruction pointer.
3. The CPU sends the address within the instruction pointer to memory on the address bus.
4. The CPU sends a “read” signal to the control bus.
5. Memory responds by sending a copy of the state of the bits at that memory location on the
data bus, that the CPU then copies into its instruction register.
6. The instruction pointer is automatically incremented to contain the address of the next
instruction in memory.
7. The CPU executes the instruction within the instruction register.
8. Go to step 3
Steps 3, 4, and 5 are called an instruction fetch. Notice that steps 3 – 8 constitute a cycle, the instruction execution cycle. It is shown graphically below.
A DMA controller can generate memory addresses and initiate memory read or write cycles. It contains several hardware registers that can be written and read by the CPU. These include a memory address register, a byte count register, and one or more control registers.
Answer:
thrust washer
can be used to eliminate rubbing friction of wheel touching frame
I think if both the parents are heterozygous. Then if you do a punnet square the last box would be tt. There you go!
I believe A is the answer: creat materials for electrical cables
Hope this helps you have a great day
