Answer: USB-C
I am 99.5% sure bcuz Im about 90 % because HDMI goes into TVs and stuff
Answer:
enable the used ports in the router with their respective IP address and only the connected ports in the switch. Allow configure the STP on the switch
Explanation:
Network switches are used to connect a group of computer devices in a network LAN. It is automatically enabled when a port is connected and creates a MAC address table of the computers connected to it. STP or spanning-tree protocol is a protocol used to prevent looping in a switch. Unused ports can be disabled for security reasons.
A router is a network device that is used to forward packets between networks. All used ports in a router must be enabled and configured with an IP address and subnet mask.
Answer: B
Explanation:
if each color can be represented as 8 bits and you have 3 colors total that would mean you would need 24 bits to represent the entirety of the RGB spectrum. And each bit can either be on or off so you have two choices for each one. So the total amount of colors you can have for 8bit RGB would be 
which is 16,777,216.
Answer:
batch sequence check.
Explanation:
A batch sequence check can be defined as a strategic and systematic control plan which typically involves the process of inputting a range of numbers comprising a batch and then inputting each serially numbered document.
The steps for checking an event data within a batch using a batch sequence check include the following;
I. You'll enter a range of serial numbers of the document in a batch.
II. You'll enter each serially pre-numbered document one after the other.
III. The input documents are sorted by a computer into a serial (numerical) order, match the sequence number range against the input documents, and then reports any part of the document that is missing, a duplicate and out of range.
