Answer:
t = 1.41 sec.
Explanation:
If we assume that the acceleration of the blocks is constant, we can apply any of the kinematic equations to get the time since the block 2 was released till it reached the floor.
First, we need to find the value of acceleration, which is the same for both blocks.
If we take as our system both blocks, and think about the pulley as redirecting the force simply (as tension in the strings behave like internal forces) , we can apply Newton's 2nd Law, as they were moving along the same axis, aiming at opposite directions, as follows:
F = m₂*g - m₁*g = (m₁+m₂)*a (we choose as positive the direction of the acceleration, will be the one defined by the larger mass, in this case m₂)
⇒ a = (
= g/5 m/s²
Once we got the value of a, we can use for instance this kinematic equation, and solve for t:
Δx = 1/2*a*t² ⇒ t² = (2* 1.96m *5)/g = 2 sec² ⇒ t = √2 = 1.41 sec.
Answer:
A) B = 0.009185 T
B) Drection is negative y-direction
Explanation:
A) We are given;
Speed(v) = 2.5 x 10^(7) m/s
Acceleration (a) = 2.2 x 10^(13) m/s²
We also know that charge of proton(q) = 1.6 x 10^(-19)
Mass of proton(m) = 1.67 x 10^(-27)
Now, Since the proton is moving by circular motion, this force is equal to the centripetal force which is given as;
F = qvBsinθ = ma
Since perpendicular, θ = 90°
And so, sinθ = sin 90 = 1
Thus, qvB = ma
Making B the subject gives;
B = ma/qv
B = (1.67 X 10^(-27) X 2.2 X 10^13)) / (1.6 X 10^(-19) X 2.5 X 10^(7))
= 0.009185 T
B) By use of Flemings right hand rule, we can see that the middle finger points toward negative y-direction, so the magnetic field is in the negative y-direction
Answer:An incandescent light bulb gives only energy of the system in the form of heat. ... The roof of a house is stable but it receives energy from the surroundings and transfers energy through it towards lower temperature side which includes no mass transfer. So, it is best considered as closed system.
Explanation:
To solve this problem we will consider the concepts related to the normal deformation on a surface, generated when the change in length is taken per unit of established length, that is, the division between the longitudinal fraction gained or lost, over the initial length. In general mode this normal deformation can be defined as

Here,
= Change in final length
and the initial length 
PART A)




PART B)




PART C)




Therefore the rank of this deformation would be B>C>A