Answer: A) Transformer
Explanation: A Transformer is an apparatus, device or a component in a system that is used to convert high voltage into low voltage. It is used to either increase or decrease the voltage of an alternating current.
A transformer uses the basic principle of electro magnetic induction, having two or more coils, the voltage is changed from one coil to another but with thesame frequency as alternating current energy passes through them.
Answer:
The speed will be "3.4×10⁴ m/s²".
Explanation:
The given values are:
Angular speed,
w = 7200 rpm
i.e.,
=
=
Speed from the center,
r = 6.0 cm
As we know,
⇒ Linear speed,
On putting the estimated values, we get
Now,
Acceleration on disk will be:
⇒
The microwave ovens rotate at a rate of about 0.105 rev/s.
The microwave rotation is the number of revolutions in a unit of time. To change the unit for angular velocity, assume that the quantity is multiplied by the unit it has. Then change to the desired units. The angular velocity is denoted by ω and has a magnitude of 6.3 rev/min.
ω = 6.3 rev/min
- 1 minute = 60 seconds
- The revolution unit didn't change
ω = 0.105 rev/s
Learn more about Angular velocity here: brainly.com/question/29344944
#SPJ4
<h2>
Answer:</h2>
Deductive reasoning
<h2>
Explanation:</h2>
The process of using pre-existing knowledge to make logical conclusions, make predictions and draw out explanations is called reasoning. Reasoning are basically of two types:
i. Deductive reasoning: This takes a general rule, idea, or theory as foundation and then proceeds from there to draw meaningful conclusions or predictions. For example;
<em> If a = 3 ----------------(i)</em>
<em> And b = 5 ----------------(ii)</em>
<em> Then 2a + 4b = 26 -------------(iii)</em>
From above, following from equations (i) and (ii), it can be concluded that (iii) should be true.
ii. Inductive reasoning: While deductive reasoning moves from a general rule to specific rule, inductive reasoning does the opposite - moves from specific to a general rule.
The final volume of the gas is 144.25 L
Explanation:
For an ideal gas kept at constant pressure, the work done by the gas on the surroundings is given by
where
p is the pressure of the gas
is the initial volume
is the final volume
For the gas in the cylinder in this problem,
p = 2.00 atm
And we also know the work done,
W = 288 J
So we can solve the equation for , the final volume:
Learn more about ideal gases:
brainly.com/question/9321544
brainly.com/question/7316997
brainly.com/question/3658563
#LearnwithBrainly