Answer:
The mirror is opaque while the lens is transparent
Explanation:
The lens is transparent throughout (lets light pass through), while the mirror reflects light. You are basically asking for the difference between a lens and a mirror
But how about the the behaviors of the convex mirror and convex lens? The convex lens will let light pass through and focus it on the other side of it. If you stand on one side of the lens, you can see what is on the other side of it. Think about a camera lens that's just curved!The convex mirror will reflect the light on the same side of it you'll basically will just see yourself but you'll look funny.
Answer:
2000 nickels
Explanation:
One way to solve proportionality problems, direct and inverse: the simple 3 rule.
If the relationship between the magnitudes is direct (when one magnitude increases so does the other), the simple direct rule of three must be applied.
On the contrary, if the relationship between the magnitudes is inverse (when one magnitude increases the other decreases) the rule of three simple inverse applies.
The simple 3 rule is an operation that helps us quickly solve proportionality problems, both direct and inverse.
To make a simple rule of three we need 3 data: two magnitudes proportional to each other, and a third magnitude. From these, we will find out the fourth term of proportionality.
In the simple three rule, therefore, the proportionality relationship between two known values A and B is established, and knowing a third value C, a fourth value D is calculated.
A -> B
C -> D
Calculation
1 nickel --> 5 g
X? nickel --> 10000g
X = (10000 g * 1 nickel) / 5 g
X = 2000 nickels
They all end with suffix "-ide"
In short, Your Answer would be Option C
Hope this helps!
Answer:
It is conserved
Explanation:
Converted to heat energy due to the friction caused by the box rubbing on the floor
Answer:
To find the diameter of the wire, when the following are given:
Resistivity of the material (Rho), Current flowing in the conductor, I, Potential difference across the conductor ends, V, and length of the wire/conductor, L.
Using the ohm's law,
Resistance R = (rho*L)/A
R = V/I.
Crossectional area of the wire A = π*square of radius
Radius = sqrt(A/π)
Diameter = Radius/2 = [sqrt(A/π)]
Making A the subject of the formular
A = (rho* L* I)V.
From the result of A, Diameter can be determined using
Diameter = [sqrt(A/π)]/2. π is a constant with the value 22/7
Explanation:
Error and uncertainty can be measured varying the value of the parameters used and calculating different values of the diameters. Compare the values using standard deviation
