Answer:
The strain is 0.0947.
Explanation:
Strain is the ration of change in dimension to the original dimension under application of load. Depending upon load, the bar may stretch or compress. So, the strain can be negative in case of compression or positive in case of tension.
Step1
Given:
Original length of the steel bar is 0.66 ft or 7.92 in.
Stretch in the bar is of 0.75 in.
Calculation:
Step2
Strain is calculated as follows:


e = 0.0947
Positive sign is for stretching condition of the bar.
Thus, the strain is 0.0947.
Answer: its an Ignition coil
Answer:
Plain Sawn. At least 95 percent of all hardwood lumber commercially produced in the U.S. is flat or plain sawn. ...
Quarter Sawn. In this method, the log actually is cut into quarters, then sawn quarter by quarter. ...
Explanation:
Complete Question
The complete question is shown on the first uploaded image
Answer:
a) The elongation of the composite bar is given as δ = 0.072 in
b) The axial stress induced in each material is = 5485.7 psi
Explanation:
The explanation to the answer above is shown on the second uploaded image
Answer:
(NH4)2Cr2O7→Cr2O3+N2+4H2O
Explanation:
(NH4)2Cr2O7→Cr2O3+N2+4H2O