1answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
Vikki [24]
2 years ago
14

A pressure-temperature curve shows that pressure and temperature are ____ in a refrigeration system.

Engineering
1 answer:
erica [24]2 years ago
7 0

A pressure-temperature curve demonstrates that pressure and temperature are directly related in a refrigeration system.

<h3>What is refrigeration system?</h3>

In both commercial and residential settings, refrigeration systems are crucial because they provide cooling or maintain a specific room temperature. With a refrigerant flowing through the units, a refrigeration cycle entails heat exchange, compression, and expansion. The cold room's refrigeration system keeps it running.

It is merely a method of moving heat from one location to another. The method of refrigeration that is most frequently utilized is the vapor-compression system. It is widely employed in sizable cold spaces, such as commercial chillers. A physiological technique for monitoring or diagnosing acute respiratory distress syndrome during mechanical ventilation is the pressure-volume (PV) curve.

Hence, A pressure-temperature curve demonstrates that pressure and temperature are directly related in a refrigeration system.

To learn more about refrigeration system refer to:

brainly.com/question/26395073

#SPJ4

You might be interested in
The moisture content in air (humidity) is measured by weight and expressed in pounds or ____________________.
VikaD [51]

Moisture content is measured in terms of pounds of water per pound of air (lb water/lb air) or grains of water per pound of air (gr. of water/lb air).

Hope this helps❤

3 0
3 years ago
Find the total amount of heat in Q lost through a wall 10' by 18' , with R value from q. 1. Inside temperature is 70 degrees F w
marissa [1.9K]

Answer:

Just think

Explanation:

6 0
4 years ago
Read 2 more answers
Problem 4 You are designing a circuit to drive LED1, using the following circuit. The datasheet for the LED specifies that VF =
HACTEHA [7]

Answer:

a) I_LED= 1/6 A  b) Vf= 2.5V

Explanation:

Consider circuit in the attachment.

a) We will simplify current source in paraller with resistor to a voltage source in series with a resistor(see attachment 2)

Solving the circuit in attachment 2 using mesh analysis

-9+2I1+4(I1-I2)-4+2I1=0

8I1 - 4I2= 13 ............... eq 1

4+4(I2-I1)+ I2 + 2=0

4I1- 5I2 = 6 ............ eq 2

I1= 41/24 ;  I2 = 1/6; I2= I_LED

b) Solving the circuit in attachment 2 again, this time I2=0

8I1 - 4I2= 13

8I1- 4(0)=13

I1= 13/8

Vf= 4(I1- I2) -4

I2=I_LED=0

Vf= 2.5 V

4 0
4 years ago
A ring-shaped seal, made from a viscoelastic material, is used to seal a joint between two rigid pipes. When incorporated in the
scoundrel [369]
I’m not sure what this question is talking about. I will get back to you later on this let me rethink it. 2.22578
3 0
3 years ago
A loss in value caused by an undesirable or hazardous influence offsite is which type of depreciation?
Lubov Fominskaja [6]

External depreciation may be defined as a loss in value caused by an undesirable or hazardous influence offsite.

<h3>What is depreciation?</h3>

Depreciation may be defined as a situation when the financial value of an acquisition declines over time due to exploitation, fray, and incision, or obsolescence.

External depreciation may also be referred to as "economic obsolescence". It causes a negative influence on the financial value gradually.

Therefore, it is well described above.

To learn more about Depreciation, refer to the link:

brainly.com/question/1203926

#SPJ1

5 0
2 years ago
Other questions:
  • Given a 8-bit ripple carry adder and the following four input scenarios: (i) A4 + 1F, (ii) AB+55, (iii) CA+34, (iv) 6D+29. a) Un
    5·2 answers
  • (I'm bored and have points to blow so here is a riddle. Don't try to look it up, I made it up just now.)
    14·2 answers
  • Write a simple phonebook program that reads in a series of name-number pairs from the user (that is, name and number on one line
    12·1 answer
  • Which of the following is NOT a problem associated with surface mining?
    13·1 answer
  • Why did the dodge demon cross the road
    9·2 answers
  • 1. (15) A truck scale is made of a platform and four compression force sensors, one at each corner of the platform. The sensor i
    12·1 answer
  • Explain Flags in ARM Processor​
    5·1 answer
  • Calculate the number of vacancies per cubic meter for some metal, M, at 783°C. The energy for vacancy formation is 0.95 eV/atom,
    11·1 answer
  • You installed a new 40 gallon water heater with a 54,000 BTUh burner. The underground water temperature coming into the house is
    9·1 answer
  • Urgent please help!<br> What are non-ferrous metal and ferrous metal?
    11·1 answer
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!