Answer:
28.20 mL of the stock solution.
Explanation:
Data obtained from the question include the following:
Molarity of stock solution (M1) = 12.1 M
Volume of diluted solution (V2) = 350.0 mL
Molarity of diluted solution (M2) = 0.975 M
Volume of stock solution needed (V1) =..?
The volume of stock solution needed can be obtained by using the dilution formula as shown below:
M1V1 = M2V2
12.1 x V1 = 0.975 x 350
Divide both side by 12.1
V1 = (0.975 x 350)/12.1
V1 = 28.20 mL.
Therefore, 28.20 mL of the stock solution will be needed to prepare 350.0 mL of 0.975 M HCl solution.
Answer:
The answer to your question is pH = 6.3
Explanation:
Data
pH = ?
[H⁺] = 4.73 x 10⁻⁷ M
pH is the measure of the concentration of [H⁺]. pH measures the acidity of the solution. If the value of pH is between 0 and 6.9, the solution is an acid. If the pH is 7.0 the solution is neutral and if the pH is between 7.1 and 14, the solution is an alkali.
Formula
pH = -log[H⁺]
Substitution
pH = -log[4.73 x 10⁻⁷]
-Simplification
pH = - (-6.3)
-Result
pH = 6.3
I believe it's webbed feet
Answer:
A) Separating funnel method
B) Simple Distillation
C) Evaporation
D) Sublimation
E) It is based on the principle of separation whereby even though two substances are dissolved in the same solvent, their respective solubilities could be different. Thus, the component that has more solubility will rise fastest and will therefore get separated from the mixture.
Explanation:
A)
B) Kerosene and petrol are both miscible liquids and the difference in their boiling point temperature is not more than 25°C. Thus, we make use of Simple distillation.
C) Can be separated by evaporation where the water is boiled and it evaporates and leaves the salt behind
D) To separate camphor from salt, we use sublimation so the camphor can change directly from solid to the gas state without passing through the liquid state.
E) Chromatography is used to separate components of a mixture.
It is based on the principle of separation whereby even though two substances are dissolved in the same solvent, their respective solubilities could be different. Thus, the component that has more solubility will rise fastest and will therefore get separated from the mixture.
Answer: Option (c) is the correct answer.
Explanation:
When a weak acid reacts with a strong base then it results into the formation of a basic solution. Hence, the resulting solution will always have a pH greater than 7.
Since, at the equivalence point number of hydrogen ions become equal to the hydroxide ions. Therefore, pH of solution will be about 7.
So at the equivalence point, the weak acid will get neutralized due to the addition of strong base. Therefore, it will lead to the formation of conjugate base.
As a result, the solution will become slightly basic in nature.
Thus, we can conclude that at the equivalence point, the acid has all been converted into its conjugate base, resulting in a weakly acidic solution because at the equivalence point, the acid has all been converted into its conjugate base, resulting in a weakly basic solution.
