Power in most circuits could be analysed and broken down into two categories
-Power dissipated by resistive components
-Power delivered by the electrical sources.
If you are working with Alternate current (AC) sources, the analysis of the power consumed in the circuit will deal with complex numbers and the introduction of new terms such as active, reactive and apparent power.
All this depending on the frequency and the components used in the circuit.
When plane is going towards Halifax the speed of wind is in the direction of fly
so overall the net speed of the plane will increase
while when he is on the way back the air is opposite to flight so net speed will decrease
now the total time of the journey is 13 hours
out of this 2 hours he spent in mathematics talk
so total time of the fly is 13 - 2 = 11 hours
now we have formula to find the time to travel to Halinex
time taken to reach back
now we have total time
here d= 3000 miles
solving above quadratic equation we will have
so speed of plane will be 550 mph
Answer:
As a result, if the field lines are close together (that is, the field line density is greater), this indicates that the magnitude of the field is large at that point. If the field lines are far apart at the cross-section, this indicates the magnitude of the field is small. (Figure) shows the idea.
Explanation:
Id say d because it releases hydrogen and on the other hand a base receives it
<span />
Answer:
Final velocity will be 556.8 m/sec
Explanation:
We have given the average rate of change of velocity that is
Time
Initial velocity of bullet will be zero that is u=0
Now according to first law of motion
v=u+at, here v is final velocity, u is initial velocity and t is time
So