Answer:
Technician B who says that low compression on a single cylinder will affect the engine’s cranking sound
Explanation:
if you have low compression in one cylinder, the engine will start but you'll likely experience misfires and your vehicle will run roughly.
It's only when you have no compression at all that the engine will not start.
The technician that said that low compression on a single cylinder will affect the engine’s cranking sound is correct.
Answer: A,C,D,E are correct statements of an inductor
A. When an inductor and a resistor are connected in series with a DC battery, the current in the circuit is reduced to zero in one time constant.
C. An inductor always resists any change in the current through it.
D. When it is connected in a circuit, an inductor always resists having current flow through it.
E. Inductors store energy by building up charge.
Answer:
This will require 266.9 of heat energy.
Explanation:
To calculate the energy required to raise the temperature of any given substance, here's what you require:The mass of the material, m The temperature change that occurs, ΔT The specific heat capacity of the material,
c
(which you can look up). This is the amount of heat required to raise 1 gram of that substance by 1°C.
Here is a source of values of
c for different substances:
Once you have all that, this is the equation:
Q=m×c×ΔT(Q is usually used to symbolize that heat required in a case like this.)For water, the value of c is 4.186g°C So, Q=750×4.186×85=266=858=266.858
Answer:
NFC Near Field Communication
Explanation:
The Near Field Communication is a communication protocol, for extra short distance with a maximum of 10 centimeters, but usually used in 4 to 5 cm. Its intended to be used in contactless pay systems and in transportation card. Actually has been used to transfer multimedia from cell phones and other devices. The maximum data rate is around 424 kbit/s, with mean in 250 Kbp
<h2>
Answer:</h2>
<em>Hello, </em>
<h3><u>
QUESTION)</u></h3>
<em>✔ We have: KE = PE (potential energy) </em>
<em>PE = m x g x h </em>
The potential energy that the pebble of mass 1 has is called PE1 and the potential energy that the pebble of mass 2 has is called PE2
PE1 = PE2 ⇔ PE1/PE2 = 1
The mass m1 is therefore 4 times greater than that of the stone of mass m2.
