<span>P = energy/t = 0.0025/1E-8 = 250000 W
I(ave) = P/A = 250000/(pi*0.425E-3^2) = 4.4056732E11 W/m^2
I(peak) = 2I(ave) = 8.8113463E11 W/m^2
Electric field E = sqrt(I(peak)*Z0) = 1.8219499E7 V/m, where
free-space impedance Z0 = sqrt(µ0/e0) = 376.73031 ohms</span>
Answer:
(A) FM Radio had a somewhat shorter ranger than AM radio, but better sound quality.
Explanation:
FM Radio was invented in 1933 by Edwin Armstrong who was an American engineer. FM stands for frequency modulation and AM stands for Amplitude Modulation.
FM is used for most broadcasts of music and FM radio stations use a very high-frequency range of radio frequencies.
In FM Radio, the sound is transmitted through changes in frequency. Both FM and AM radio signals experience frequent change in amplitude, they are far less noticeable on FM.
When switching between stations, FM antenna is alternating between different frequencies, and not amplitudes and this produces a much clearer sound and allows for smoother transitions with little to no audible static.
FM signals can be interfered by barriers and this could affect the signal strength. FM Radio signals are more clearer in a mountainous area that has no barrier.
AM radio was able to carry signals farther than AM radio.
Answer:
f = 1.18 x 10¹¹ Hz
Explanation:
The equation used to find frequency is:
f = c / w
In this form, "f" represents the frequency (Hz), "c" represents the speed of light (3.0 x 10⁸ m/s), and "w" represents the wavelength (m).
Since you have been given the value of the constant (c) and wavelength, you can substitute these values into the equation to find frequency.
f = c / w <---- Formula
f = (3.0 x 10⁸ m/s) / w <---- Plug 3.0 x 10⁸ in "c"
f = (3.0 x 10⁸ m/s) / (2.55 x 10⁻³ m) <---- Plug 2.55 x 10⁻³ in "w"
f = 1.18 x 10¹¹ Hz <---- Divide
Answer:
Hello, I believe it would have a negative charge considering protons have a positive charge while elctrons have a negative charge
Explanation:
The radius of the cylinder is equal to half the diameter:

The volume of the cylinder is given by:

where h is the heigth of the cylinder. Converting into meters,

And the density of the material will be given by the ratio between the mass and the volume:
