Answer : The final temperature is,
Explanation :
In this problem we assumed that heat given by the hot body is equal to the heat taken by the cold body.
where,
= specific heat of ice =
= specific heat of water =
= mass of ice = 50 g
= mass of water = 200 g
= final temperature = ?
= initial temperature of ice =
= initial temperature of water =
Now put all the given values in the above formula, we get:
Therefore, the final temperature is,
0.02020 ohm is the resistance of a carbon rod at 25.8 ∘C if its resistance is 0.0200 Ω at 0.0 ∘C.
<h3 /><h3>What is a resistor?</h3>A resistor is an electrical component that controls or restricts how much electrical current can pass across a circuit in an electronic device. A specified voltage can be supplied via resistors to an active device like a transistor.
The temperature of the resistor varies based on the variation in the temperature. The equation that describes the relationship between the two of them is:
R = R0[1+ alpha(T-T0)] where:
R is the new resistance we are looking for
alpha is the temperature coefficient of resistance. For carbon rod, alpha = ₋ 4.8 x (1/°c)
T0 is the standard temperature =25.8°C
R0 is the resistance at T0 = 0.0200 ohms
T is the temperature at which we want to get R = 0
Substitute in the equation to get R as follows:
R = 0.0200 [1+( ₋ 4.8 x ) (0-25.8)] = 0.02020 ohm
To know more about resistance refer to: brainly.com/question/11431009
#SPJ1
Answer:
B.) by interfering with sound waves
Explanation:
As we know that the interference of sound waves is of two types
1). constructive interference
2). destructive interference
now we know that constructive interference means the resultant intensity will be more than the intensity of interfering waves as here two waves are in same phase.
In destructive interference the resultant of two waves is given by the minimum resultant of the intensity as here the phase of two waves are opposite to each other.
So we will say that
here in case of noise cancelling headphones we know that the phase of noise is always made in opposite phase with the sound which is used to cancelled the noise.
This will reduce the noise and we will get a clear sound
Answer:
1.85 J/K
Explanation:
The computation of total change in entropy is shown below:-
Change in Entropy = Sum Q ÷ T
=
= -3.12 + 4.97
= 1.85 J/K
Therefore for computing the total change in entropy we simply applied the above formula.
As we can see that there is heat entering the reservoir so it will be negative while cold reservoir will be positive else the process would be impossible.